This "how to" only applies to 89-94 240SX's (S13's). I'm not sure about s14's but the procedure is most likely pretty similar. Removing the rear bumper is actually much easier than the front bumper, it's just knowing what bolts to remove that's the toughest part. First thing you need to do is remove both the carpet and side trim panels in the trunk, to allow you to gain access to the necessary bolts. Once that is done, remove the nuts that hold the rear bumper to the rear quarter panels. To get an idea where these bolts would be, look on the outside of the car and look at the seam between the rear bumper and quarter panel. There should only be three on each side. Next, there are 4 rubber gromets (rubber caps) covering four 14mm bolts in the trunk. There are two on each side of the spare tire well and are in line with each other. These bolts are what holds on the rear bumper support. Remove those, and the bumper should come right out with the bumper support attached. You may notice that there are wires still attached to the bumper, these wires are for the license plate lights and can be unplugged once the bumper is pulled partially out. Once you have the bumper and bumper support freed from the car, you can easily remove the bumper from the support by removing some screws. Cheers!
-Andrew
how to remove 2013 passat rear bumper
Remove rear bumper on 99 ford tarrus
how do you remove and replace rear bumper on an xtype jag
Removing the Rear Bumper of a Passat...
To remove the rear bumper on the 2005 Nissan Sentra, you will first need to remove the rear bumper cover by using a flat tool to pry the pins. Then, access the bolts holding the bumper to the frame of the vehicle and remove the nuts. The bumper will then lift off.
The 1992 Mercedes-Benz 300 rear bumper is held in place with eight retaining bolts. You can remove the rear bumper by removing the retaining bolts.
The 1994 Ford Explorer rear bumper is held in place with eight retaining bolts. Remove the retaining bolts and the rear bumper will come off.
The rear bumper is held in place with eight retaining bolts. Remove the retaining bolts and the rear bumper will come off. Reverse the process to install your new rear bumper.
The 2007 Santa Fe rear bumper is held in place by eight retaining bolts. Remove the retaining bolts and the bumper will come off.
Have a crunched driver side rear corner bumper. Looking for tips how to remove the skin. Thanks Dorel
The rear bumper on a Honda Civic is held on using several mounting screws. After remove each screw the bumper will be held on with mounting clips. The bumper can be gently pulled off.
To remove the rear bumper cover on a 1993 Ford Taurus wagon, the lights need to be disconnected in the rear. Once all electrical connections are disconnected in the rear, remove the taillights and the fuel filler overflow hose. Remove any nuts and bolts holding the bumper cover on. Using needle nose pliers, pop the push pins around the bumper cover upwards. Slowly pull on the bumper to remove it.