Takes some finess and strength at same time. There are two tabs, heavy spring like metal tabs, push seat bottom at both sides and then pull up at same time, so push seat bottom back and lift, it should release.
RecessionProof-Business.com
There are 3 flat head screws to remove. One is at the rear of the passenger seat. one each under the side flaps of the seat. after removing the 3 screws, pull seat to the rear to remove from tongue.
THE FUEL FILTER IS IN THE FUEL TANK, THERE IS A ACCESS PANEL UNDER THE REAR SEAT. So I would have to remove the rear seat from the inside of my 2004 kia sorento?
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
To remove the rear seat on my 91 535i you have grab under the seat about half way and then pull straight up. Hope this helps you out
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
How do you remove the rear seat on a 2002 diamante
Remove rear seat and panel underneath seat. How do I remove rear seat?!?!
You will need to first fold the seat down. Once you have done this you can lift up the seat latch handle and disengage the seat from the hooks in the floor.
To remove the rear seat of a 2004 Jeep Liberty, start by locating the seat release mechanisms, which are typically found at the base of the seat cushions. Lift the front of the seat cushion and pull it up to detach it from the clips holding it in place. For the seatback, look for bolts or fasteners at the bottom and sides; you may need a socket wrench to remove these. Once the bolts are removed, you can lift the seatback out of the vehicle.
To remove the rear seat on a 2004 Toyota Camry, first, locate the release tabs or bolts at the base of the seat cushion. Pull up on the front of the seat cushion to disengage it from the clips, then lift it out. For the seatback, look for bolts or clips at the bottom and sides, remove them, and then pull the seatback upward and out. Always consult the owner’s manual for specific instructions and safety precautions.