Remove the screws on the rite hand side
I am in a bind, I need to remove lower timing belt cover of 2005 Honda Pilot, there is a bolt (10mm) at the end of timing cover (1 o'clock) right under front camshaft pulley, there is only one serpentine belt for for the engine, the serpentine belt is removed, by pushing the belt adjuster, now that belt adjuster is right in front of the 10 mm bolt that holds lower timing belt cover, do I need to remove that in order to remove cover and bolt? I have tried but its not coming off?
Right in front of the valve cover. You have to remove a cover to access it.
The water pump is located on the front or right side of the engine. To find it, remove the drive belt cover. On the front or right end of the engine. To find it, remove the drive belt cover.
Remove the right cover below the fuel tank and you get to the battery.
There are five valve cover bolts (since this is an SOHC engine it's also called a cam cover); two longer bolts in the rear and three shorter bolts in the front. You will need to remove the spark plug wires and the wire harness located on the left, front of the cover, as well as a hose on the rear left corner to remove the cover. The bolts have a 10mm head. The bolts are tightened starting with the front, middle bolt, then back right, back left, front right, and front left. They are tightened to 86 in-lbs and it is very common to over-torque them and snap them off.
Open the locked door on the tank in front of you. Remove the plastic tray, and there it is. Remove the wing nut, slide the filter cover to the right side then tilt it up towards you. Remove the air filter, and replace with a new one.
The windshield fluid pump in a Honda Element is located behind the front fascia. You will need to remove the fascia and it is right there.
The spark plug on a 2011 Honda Rancher TRX 420 is located on the right side of the engine, near the front. To access it, you may need to remove the plastic cover on the right side of the frame. The spark plug is threaded into the cylinder head and can be removed with a spark plug socket.
on top of the engine right down the middle. Have to remove to cover and front cover over timing belt.
cam cover is on the left side, the bolt that holds it on is on the right side, loosen up the bolt and tap on the bolt will cause the cover to pop off
Just in front of the rear right wheel underside but there is a cover that has 10mm bolts that you have to remove.
pull off the front ferrings and remove the two main bolts, one on the left and one on the right