answersLogoWhite

0

Remove tire and brake caliper.

Use a flat screwdriver to remove the dust cap closest to you, then the cotter pin, then the castle nut, then the flat nut, then slide out the rotor.

Make sure the replacement rotor has fully greased bearings installed. Use a new cotter pin.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you fix the egr valve on 1997 dodge b2500 van?

A 1997 Dodge Ram doesn't have a EGR valve.


How do you remove rotors on 1997 dodge vans?

Remove wheels Remove 2 caliper mounting bolts Slide caliper off rotor Rotor should slide off hub


Change front brake rotors on 1997 Dodge Intrepid?

Remove caliper, pull rotor off hub, push new one on.


Where can you find the electric door lock module in a 1997 dodge ram van 2500?

On my 1997 Dodge B2500 van the door lock manual is directly in front of the radio at the center of the dash (below the windscreen glass).


How do you replace rotors on 1997 Dodge van?

To replace the rotors on a 1997 Dodge van, first, safely lift the front or rear of the vehicle and remove the wheel. Next, remove the brake caliper by unbolting it, and then slide it off the rotor; secure it to avoid stressing the brake line. Remove the rotor by unscrewing any retaining screws if present, or simply pulling it off the hub. Install the new rotor, reattach the caliper, and ensure everything is securely fastened before replacing the wheel and lowering the vehicle.


How do you replace the power steering gear box on a 1997 dodge ram b2500?

To replace the power steering gear box on a 1997 Dodge Ram B2500, first, safely lift the vehicle and remove the front wheels for better access. Disconnect the power steering lines and the pitman arm, then unbolt the gear box from the frame. Install the new gear box by reversing the removal steps, ensuring all connections are secure, and refill the power steering fluid before bleeding the system to remove any air. Finally, test the steering for proper function.


How do you remove rotor on a 1997 Ford 250 diesel?

you take it out


Where is the fuel pressure regulator located on 1997 Dodge Ram B2500?

On the pump inside the tank.On the pump inside the tank.


What freon is used in a dodge B2500 van 1997?

The 1997 Dodge B2500 van typically uses R-134a refrigerant for its air conditioning system. This was the standard refrigerant adopted for vehicles after the phase-out of R-12 due to environmental regulations. If you're servicing the AC, it's important to verify the system for any retrofitting that may have occurred. Always consult the owner's manual or a professional for specific guidance.


What does GEN stand for on the message center of an 1997 dodge B2500 van?

The generator ( alternator ) is not charging properly.The generator ( alternator ) is not charging properly.


How do you remove rotor on 97 Ford Aspire?

To remove the rotor on a 1997 Ford Aspire, first, ensure the vehicle is securely lifted and supported. Remove the wheel, then take off the brake caliper and its bracket to access the rotor. If the rotor is held in place by screws, remove those; otherwise, gently tap the rotor with a mallet to loosen it if it's stuck. Finally, slide the rotor off the hub and replace or service as needed.


How do you change a 1997 dodge caravan v6 engine distributor cap and rotor?

The cap is held on by two screws. Counter clockwise to remove. The rotor will pull right off. Swap the plug wires from old cap to new one at a time, so they do not get in wrong locations. Reverse to install.