there are two bolts in the back of the seat. remove them and then slide the seat back about an inch and remove
what is the fuel pressure in a kawasaki prairie 700 4X4
To remove the carburetor on a Kawasaki Prairie 700, first, ensure the engine is off and cool. Disconnect the battery, then remove the air filter and intake boot to access the carburetor. Next, detach the fuel line, throttle cable, and any electrical connections before loosening the mounting bolts to lift the carburetor out. Be sure to take note of the order of disassembly for reinstallation.
To remove the seat on a Polaris XC 700, start by locating the seat release mechanism, which is typically a latch or bolts at the rear of the seat. If it’s a bolt, use the appropriate tool to unscrew it. Once the latch or bolts are released, lift the seat from the rear and slide it forward to detach it completely. Ensure to also check for any additional clips or fasteners if necessary.
I saw 120 with soft saddlebags on. kz700 A4
700 cc or .74 qt
There's a button on the handle bars that says "on". Press it.
I had my 1985 700 Honda shadow topped out at 124mph. It didn't matter if it was in 5th or 6th gear it was 124mph throttle pulled all the way back for at least a minute at 124mph. I was racing a 1980 Z28 Camaro when I did this on a cool October night. I owned a 2006Kawasaki 750 Vulcan and the top speed I could ever get out of it was 111mph. The 700 shadow smoked the 750 Vulcan in top speed, but the 750 Vulcan was quicker. I ran my Vulcan 750 at Mokan Dragway with my best time of 14.98 at 89mph.
The 700 Club - 1966 Pergamum The Seat of Satan was released on: USA: 22 July 2011
The VIN (Vehicle Identification Number) on a Kawasaki Prairie 700 4x4 is typically located on the frame, specifically on the right side, near the rear of the vehicle. It can often be found near the rear wheel area or on the left side of the frame, depending on the model year. It's usually stamped into the metal, making it durable and difficult to remove. Always refer to the owner's manual for the exact location specific to your model.
I think 700 cc or .7 Liters
the 450 in fact you can even see races between the two on youtube
release the helmet latch (keyhole on the left hand side of the bike, below the rear part of the seat), then push in the lever behind the latch. Push "in" meaning toward the front of the bike.