well, you must first have knowledge of weed wackers. call me if you need help. 678-434-8521
The pull cord on a Homelite trimmer is repaired by removing the outer cover and pulling out the cord spool. A new line is then attached, wound around the spool, and put back in place.
yes
Installing new string on a Homelite 26ss weed eater is very easy. You will need to take off the empty spool and put the new one on. Take two pieces of the strings and put each in one of the empty slots opposite each other. The put the spool and grasp the strings pulling them into place.
Stop motor. Remove line spool. pull spool from shaft and remove cord or weeds from around shaft. Replace spool on shaft. Re start motor.
pull straight out to remove the spool, wind in the direction of the arrow - to replace, feed the string through the hole and pull on it, keeping slight tension on the spool as you push it back into the head
Spool pins are used on sewing machines to hold the spool of thread. Most or vertical, some that are horizontal use a spool cap to secure the spool of thread. Some machine come with spool nets to cover the spool to ensure the thread enter the machine evenly. Some machines come with an extra spool pin that fits into a small hole on the top of the machine to hold a second spool of thread.
A spool of thread is very cheap. Spools of thread can be as cheap as a dollar or less a spool.
Locate the trimmer head at the shaft. Remove debris in the head. Cut a 14-inch piece of the trimmer line and fold it. Place the spool against the spindle. Feed the ends of the line through the eyelets. Push the spool down and pull the trimmer line tight with your hands. Tighten the spool.
Emma Spool was created in 1982.
A real reel is a genuine spool.
That spool is just the right size for my project.
If you are talking about a diff. A mini spool replaces the planetary gears in the diff centre. A full spool replaces the whole centre except the crown wheel.