answersLogoWhite
Starters and Ignition Systems
Oldsmobile Cutlass Supreme
Classic 1964-1978 Ford Mustangs

How do you remove the starter from 1991 cutlass supreme?

272829

Top Answer
User Avatar
Wiki User
Answered 2006-07-06 18:47:12

transmission

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


price on replaceing ball joint 1993 cutlass supreme



Begin by removing the positive cable from your 1991 Pontiac Grand Am battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.


must remove oil filter to get starter out have fun



Nee more info cutlass supreme or cutlass ceira which engine 3.1-- 3.8-- 3.3-- ????? Oldsmobile cutlass ceira 3.3 liteer engine


Follow the pos battery cable and it is at the engine end.


Remove the - battey cable Raise and support vehicle Disconnect wires at the top of starter Remove starter mounting bolts Remove starter


The brain or ecm is located on passenger side, underneath glove box. Remove a few 6mm screws and there it is behind plastic cover.


Remove the battery cable from the positive post of the battery. Remove the cables from the starter. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.


Disconnect the - battery cable Raise and support vehicle Disconnect the wiring harness at the top of starter Remove starter mounting bolts Remove starter


there is 3 wires to the starter disconnect them. Then remove the mounting bolts and detach the starter the reverse to installation


Behind the harmonic balancer (dampner) that is located behind the crankshaft pulley.


The most obvious thing to check when a 1991 Oldsmobile Cutlass Supreme won't start is to make sure that the vehicle has gas. You should also check the battery. If the car clicks when you try to start it, it is likely the alternator.


Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft


its in the gas tank u godda take the tank off


MOST LIKELY YOU WILL NEED A HOIST TO EVEN SEE THE STARTER


Unhook the negative battery cable thenlay under the car ,remove the wires off the starter then unbolt and remove it.


You'll need to remove the intake manifold. The starter is located underneath it.


Disconnect the battery, locate the starter.. remove the mounting bolts, bring the starter down to where you can reach all of the wires going to the solenoid, and disconnect those.


I have a 1991 Cutlass Supreme and I had to use a flex ratchet to replace the back 3 plugs. Other than that I was told by a mechanic friend that the motor has to come out to do this.


its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.


It is mounted on top of the transmission. You'll have to remove the airbox and peer back toward the firewall. Mine has two bolts that connect it to the transmission. The shifter rod is held on by one nut.


That depends on which engine you have, which you failed to mention. Go to the link below and pick the correct engine.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.