you need a steering wheel puller to get it off.
Disconnect battery. Remove air bag. Remove bolt holding steering wheel to column. Use a steering wheel puller to remove wheel from column.
No. You can remove the entire column with the steering wheel still attached.
How to Remove the Steering wheel From a Chevy Blazer 2001
Usually, the bolt to remove the steering wheel from the column is located at the point where it attached to the column. If your steering wheel has a pressure switch for the city horn located in the center of the steering wheel, you'll have to remove it to access that bolt.
remove the center padded section on the steering wheel and you will see a large nut holding the wheel on, loosen the and take it off and then you will need a wheel puller to pull the wheel back off of the splines to take it off.
To remove the steering wheel start by disconnecting the negative battery terminal to prevent accidental airbag deployment. Then remove the screws on the backside of the steering wheel to remove the airbag. Disconnect the airbag wiring connectors. Remove the steering column shaft nut and remove the steering wheel with a puller. Do not yank, hammer, pry the steering wheel off as this could result in steering shaft damage.
The steering column.The steering column.
Remove horn ring or button (twist to remove) Remove center bolt on steering wheel Mark location of wheel in relation to steering column shaft for proper re-install Get and attach a steering wheel puller Tighten nut on wheel puller until steering wheel "pops" off
remove steering wheel and then it's pretty self explanatory.
To replace an Isuza Rodeo steering the steering column should first be removed. Pop off the front steering wheel cover to see the steering wheel nut. Loosen the nut and remove the wheel.
I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck!
Remove two screws 10mm from back of steering wheel,take the air bag part off the steering wheel after removing the two screws,then there should be one big bolt that you haft to remove . The steering wheel will come right off..