0
Avensis 2004 (2003-2007 model)
Removed as there was something rolling around inside the steering wheel, causing the horn to randomly activate
Unit has airbag, I didn't fancy the idea of the unit going off so I disconnected the battery as a precaution
Loosen the two "torx" screws on either side of the steering wheel (on sides next to the stereo controls on one side and blank/cellphone controls on the other side) , they will loosen, but not completely come out as they are held in by a plastic "cage".
Use a magnet to 'hold' one of the torx screws out as far as possible, whilst slowly wiggling the centre of the steering wheel out on that side (it won't completely remove), repeat the same on the other side, the centre should now come out (it's a firm fit), but note that the removed piece is still connected via cables (for the airbag), I did not need to remove these to perform my repair, so I am unsure as to what would be required to 'reset' airbag (if anything) once these are disconnected.
The torx screws need to be located in the plastic cages (on the recess on the Torx screw head) to hold them in place whilst refitting the centre of the steering wheel.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the horn located on a Toyota avensis?
On the steering wheel. You press the middle part in!
What is a wheel bolt pattern Toyota avensis?
5x100 54.1 et45
How do you replace the steering wheel on 1997 Toyota Camry le?
You need to get a special tool, steering wheel puller. If you have it, disconnect the battery. Remove the steering wheel air bag (there are two screws holding it in place). Disconnect the bag harness. Remove the center steering wheel nut. Using the puller remove the steering wheel. Installation is reversed to removal.
How do you take steering wheel off a 93 Toyota Camry?
A steering wheel is hard to remove by hand. It can be removed with a tool called the steering wheel remover found at local auto shops.
How do you remove the steering wheel from a 2005 Toyota Corolla?
To remove a steering wheel, a person will need a steering wheel puller from an auto part store, from there after the airbag is removed, place the tool over the steering wheel and follow its directions. It will pull the steering wheel off by applying pressure to the middle and pulling everything else up.
Handbrake adjustment on Toyota avensis 04?
remove rear wheel s you will see a rubber grumett remove the flathead screw driver and adjust the wheel in side do both sides , a little at a time test drive do again if needed ....
How do you remove the steering wheel on 2004 trailblazer?
A person needs a steering wheel puller to remove a steering wheel. It will help remove the steering wheel by putting pressure on the middle and by pulling up on the rest of the steering wheel.
How do you remove the steering wheel on a 85 Chevy Celebrity?
To remove the steering wheel from your 1985 Chevy Celebrity: First remove the horn button. There should be a keeper at the tip of the steering shaft, remove it. Remove the nut that holds the wheel in place. Use a steering wheel puller to actually remove the steering wheel.
How do you remove steering wheel on frontier?
Disconnect battery. Remove air bag. Remove bolt holding steering wheel to column. Use a steering wheel puller to remove wheel from column.
How do remove the steering wheel on a 2000 Malibu?
Local car part stores have a tool called the steering wheel puller, that has to be used to remove the steering wheel. This is used to remove the steering wheel by applying pressure to the middle and pulling up on the rest of the steering wheel to remove it.
How do you remove steering wheel on a 2004 Chevy?
It can be hard to remove a steering wheel by hand on any vehicle. To remove it, there is a tool, steering wheel puller, that can be bought or rented from local auto shops. It will help remove the steering wheel.
How do you remove a steering wheel on a 2002 cavalier?
Steering wheels are hard to remove. A tool called a steering wheel puller needs to be used to remove the steering wheel. It removes the steering wheel by applying pressure to the middle and pulling the rest of the wheel up.
