0
How do you remove the steering wheel to repair horn in a 99 S10 with an airbag?
Wiki User
∙ 13y ago
Run and auxillary horn button to the dash board. It will be:
much easier
much less expensive
much faster.
On my 93 GMC S-15, I happened to find the horn relay. When looking under driver's side dash board closer in view than fuseblock there, saw this relay just to left of turn signal relay, pulled it out and it said on it, "horn." Wish I had found that a few year's ago when my horn didn't work. That might be a good thing to test or find one at wrecking yard to see if that fixes problem.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is turn signal switch on 98 explorer?
In the steering column. You'll have to remove the steering wheel with a steering wheel puller tool. This can be a dangerous repair job due to the airbag in the steering wheel. Get a Haynes or Chilton's manual for the details on how to do this as well as how to disarm the airbag system.
How do you remove the steering wheel off your 1994 mercury tracer?
4 bolts are romoved from the backsode of the steering wheel. If airbag equipped remove airbag fuse first. Then remove airbag/ horn/ center assembly. Remove large nut from center of wheel, then pull wheel with steering wheel puller.
How do you remove a steering wheel from a 1994 Mitsubishi 3000 gt?
To remove the steering wheel start by disconnecting the negative battery terminal to prevent accidental airbag deployment. Then remove the screws on the backside of the steering wheel to remove the airbag. Disconnect the airbag wiring connectors. Remove the steering column shaft nut and remove the steering wheel with a puller. Do not yank, hammer, pry the steering wheel off as this could result in steering shaft damage.
How do you disarm the airbag on a 94 camaro and remove the steering wheel?
simply pull tha airbag fuse. remove the 4 torx head scres behind the airbag and remove airbag. unplug theelectrical connector. remove the big nut holding the steering whell. use a puller to remove the steering wheel.
How do you remove the steering wheel on a 1996 Lincoln town car?
ok you have to check on your steering wheel in back of you steering wheel there will be a 2 or 4 bolts you gonna have to remove ,as soon your remove you steering wheel airbag you should see 2 wires one goes to airbag on other will be connected to you steering wheel switches ,,you should remove that and after that you gonna see one bolt you should remove it and you can after that you should be able to pull you steering wheel
How do you take the steering wheel off a Porsche 997?
you would need to disconnect the airbag then pop off the horn pad and remove the airbag then unbolt the steering wheel.
How do you remove steering wheel airbag on Corolla?
To remove an airbag from the steering wheel of a Corolla first make sure that the airbag system is disabled. Undo the two Tork screws on either side of the wheel. Once this is removed the connector for the airbag should be visible. Push the clip towards to horn pad and it should come out.
Can a 2000 Chevrolet S-10 Blazer steering wheel and airbag be replaced with an aftermarket steering wheel and no airbag?
No, it is illegal to remove the SRS from any vehicle you drive on public roads.
How do you remove a dodge stratus steering wheel with a airbag?
Have a mechanic do it. Air bags are nasty!
How do you remove 1997 Seville steering wheel?
AIRBAG WARNING: Before you remove any steering wheel parts on an airbag equipped car it is important that you disconnect the negative battery cable to disable the airbag system. A loose airbag deploying directly in your face can cause serious injury, and could possibly kill you DEAD.Having said that, I'm not sure exactly the procedure on a Seville, but I'll give you a basic run down of how to take off most steering wheels.1)Disconnect negative battery cable2)Determine how airbag module is attached to steering wheel. The airbag module is in the front center of the steering wheel and is the part of the steering wheel you see. It likely has a vehicle emblem right on it. There may be plastic covers on the side or back of steering wheel that hide airbag retainer nuts. Some airbag modules are simply held in by clips and can be pulled out. Once you determine how the airbag is fastened remove it from the steering wheel. There will be an electrical connector to the airbag (usually yellow). Carefully disconnect electrical connector and set airbag aside.2)Disconnect horn wire, and any other electrical wires used inside the steering wheel. There should be connectors for all wires.3)NOTE:ENSURE STEERING WHEEL IS POINTED STRAIGHT AHEAD PRIOR TO REMOVAL. At this stage you should have access to the steering wheel nut. Remove the steering wheel nut.Some steering wheels will simply come off at this stage. However most wheels must be pressed off. Use a steering wheel puller to pull wheel. A puller set can be rented at most auto parts stores if you don't have one.4)CLOCKSPRING WARNING:Behind the steering wheel there is a component known as a clockspring. It houses the wires for the airbag and other steering wheel electronics. It allows the steering wheel to spin and maintain electrical connections. It is important that the clockspring or wheels are not turned while the steering wheel is out. If the clockspring is turned too many times over it will break causing steering wheel electronics not to work(and an expensive repair). It must remain centered at all times.
How do you remove 1999 holden commadore drivers airbag steering wheel?
To remove the driver's steering wheel airbag on a 1999 Holden Commodore you will need a special set of tools to remove the 4 to 6 security screws that are holding it in. If the vehicle came equipped with a airbag, it needs to have one to remain road safe.
Where is the multifunction switch for a 2001 neon?
behind the steering wheel. pull off neg. battery cable, wait 2 minutes, remove airbag, remove steering wheel, and there it sits
