4 bolts are romoved from the backsode of the steering wheel. If airbag equipped remove airbag fuse first. Then remove airbag/ horn/ center assembly. Remove large nut from center of wheel, then pull wheel with steering wheel puller.
hopefully your not stealing the vehicle. but you will have to remove the steering wheel and then remove the key switch itself, purchase a new key switch and replace. However if its only to move the vehicle, after you remove the key switch you can take a screw driver and turn the mechanism in the column to unlock.
You will need a puller to remove the steering wheel, after you remove the nut and snap ring in the center of steering wheel. Ther are two holes in the wheel that are threaded. Install puller on center shaft, and screew 2 long bolts through the puller and into the holes on wheel.
Park the truck with the front wheels in the straight ahead position do not turn or the steering wheel shaft after,before or during or will damage the clockspringDisconnect the negative battery cable and wait at least 2 minutes for the airbag capacitor to discharge before proceedingIf the truck is equipped with speed control remove the switch retaining screws.Pull off the switches and unplug the electrical connectorIf equipped remove the right rear steering wheel cover using a small screwdriverRemove the 4 nuts attaching the airbag module it will probably be necessary to turn the steering wheel to gain access to the nuts; just be sure to center the wheel after the nuts are removedLift off the airbag module and unplug the electrical connector when you set the airbag module down make sure the airbag side is facing up so that if it accidentally deploys it wont launchRemove the steering wheel retaining nut and mark the position of the steering wheel to the shaft if marks don't already exist or don't line upUse a puller to detach the steering wheel from the shaft don't hammer on the shaft to dislodge the wheel
It is located behind the steering wheel. You will need to remove the steering wheel. Its a blak circular part that has a 3-5 wire plug in the back of it.
you have to remove the steering wheel. (if it has an airbag, be very careful not to set it off.) if no airbag, just remove the steering wheel, and on the ignition switch there is a bolt that simply screws out. remove the ignition switch, and replace with the new one. line up the bolt holes, and replace bolt. put steering wheel back on, and youre done.
on the steering wheel.
In the middle of your steering wheel.
A 1999 Mercury Tracer is a front wheel drive vehicle
Available option Was linked to cruise control option-usually if it had one it had the other
front
A person needs a steering wheel puller to remove a steering wheel. It will help remove the steering wheel by putting pressure on the middle and by pulling up on the rest of the steering wheel.
To remove the steering wheel from your 1985 Chevy Celebrity: First remove the horn button. There should be a keeper at the tip of the steering shaft, remove it. Remove the nut that holds the wheel in place. Use a steering wheel puller to actually remove the steering wheel.
how do you fix play in a 1997 mercury mountainer steering wheel
Local car part stores have a tool called the steering wheel puller, that has to be used to remove the steering wheel. This is used to remove the steering wheel by applying pressure to the middle and pulling up on the rest of the steering wheel to remove it.
Disconnect battery. Remove air bag. Remove bolt holding steering wheel to column. Use a steering wheel puller to remove wheel from column.
Get a manual on your car and it will have pictures and everything. It is not an easy job.