Open the tail gate and disconnect the upper end of both cables, hold the tail gate aprox half way open and pull it up and out on the passenger side first then the drivers side.
The latch assembly and cable is one piece.
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.
The left or right tailgate cable comes as an assembly that includes the left or right side tailgate latch.
where can i find a diagram for a 1997 chevy s10 brake switch?
It is part off the engine oil cap, remove it and you will see it.
the shifter is all in one. you have to replace the whole shifter. the nob is attached
Look for a?æbox located in the glove compartment marked "relays" of the 1997 Chevy S10. The horn relay is the first one on the left.
the cover does not come off, you must remove the entire light assembly and remove the bulb from the back side
i am looking for a diagram of the firing order in a 1997 Chevy s10 blazer 4x4.
1. lower tailgate 2. remove the two screws ( one of them is behind the tailgate "catch" bracket ) 3. pull out the light housing 4. the bulb holder is kind of a asprin bottle and you must push it it and turn, pull out bulb and replace
There are 2 screws for each tail light, open the tailgate to get to them, one is visible the other is in the catch for the tail gate, then they should pull out with a wiggle...
Yes.