It is located at the engine end of the upper rad hose in a housing. Remove the housing and when you replace it make sure the spring goes toward the engine.
The thermostat on a 1991 Buick Skylark is located near the engine. To find the thermostat, follow the top radiator hose directly to the thermostat.
The thermostat on 4 cylinder, 2.3L Buick Skylark is on the bottom of the water pump. Remove the metal water line connected to the bottom of the water pump to find it. Remember the new O-ring with the new thermostat.
I have a 93 buick skylark and i cant find the thermostat on the da*n thing.. can anyone explain to me on how to change it??? Follow the hose to the top of the engine where it ends. The thermostat is under the thing where the hose is attached. There are two bolts holding it down. Also, get a Chilton's or Haynes manual from Amazon. They have the procedure and the books are cheap.
Drain the water from your radiator. Remove the radiator hose, from the thermostat housing. Remove the thermostat housing retaining bolts. Replace the thermostat housing gasket and reverse the process to install the new thermostat.
follow your bottom radiator hose to the thermostat housing remove the 2 10mm screws and there is the thermostat
If you follow the hose from the drivers side of the radiator, it will lead you up to the end of the thermostat housing. It is under the air cleaner. There is a lot of stuff you need to remove to get to it. Good luck.
follow the top radiator hose and it should lead u right to the thermostat housing. remove the housing and the thermostat is inside
Skylark - 1993 TV is rated/received certificates of: Canada:PG (Ontario) USA:G
Hey Mike==Follow the upper radiator hose from the radiator to the engine and at the engine there is a housing that contains the thermostat. When replacing it make sure the spring goes toward the engine. GoodluckJoe
You Have to drop the fuel Tank And Open it Up. the Fuel Pump Sits in the Tank.
won't idle
follow the top radiator hose to the engine. that is where your thermostat is. you will have to drain the radiator, remove the engine side of the hose and remove the thermostat housing to access it. remove thermostat clean mating surface of housing and engine, install thermostat, install housing, secure radiator hose, fill with coolant. start engine and check for leaks.