To remove the washer nozzles on a Pontiac Vibe, first, gently pry off the plastic cover surrounding the nozzles using a flathead screwdriver or a similar tool. Once the cover is off, you can squeeze the tabs on the sides of each nozzle to release them from the hood. Disconnect the washer fluid hoses attached to the nozzles, and they should come free. Be cautious not to damage the surrounding paint or components during the process.
To replace the windshield washer hose on a 2005 Pontiac Vibe, first, locate the damaged hose, which typically runs from the washer pump to the nozzles on the hood. Disconnect the old hose by unclipping it from any retainers and pulling it off the fittings. Measure and cut a new piece of hose to the correct length, then attach it to the pump and the nozzles, securing it with clips if necessary. Finally, test the system to ensure there are no leaks and that the washer fluid sprays properly.
Both washers use the front reservoir
To replace the windshield washer pump on a 2004 Pontiac Vibe, start by disconnecting the negative battery terminal to ensure safety. Remove the washer fluid reservoir by unscrewing any bolts or clips holding it in place, then disconnect the electrical connector and the washer fluid hoses from the pump. Replace the old pump with the new one, reconnect the hoses and electrical connector, and reassemble the reservoir. Finally, reconnect the battery and test the new pump to ensure it’s functioning properly.
Pontiac Vibe was created in 2002.
To refill the windshield wiper fluid for the rear window of a 2003 Pontiac Vibe, locate the washer fluid reservoir under the hood. Open the hood and find the reservoir, which typically has a blue cap marked with a windshield symbol. Remove the cap and pour in the appropriate washer fluid until it reaches the desired level. Replace the cap securely before closing the hood.
VERY carefully....:)
Remove the positive cable from your 2004 Pontiac Vibe battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
The front wheel bearings, of a Pontiac vibe, can be replaced by first removing the front wheel. Next, remove the axle end cap. Remove the bearing and reverse the process to install the new bearing.
http://forums.genvibe.com/zerothread?id=26369
where is the internal fuse box on a 2008 pontiac vibe
Changing transmission cables on a 2006 Pontiac vibe
Counter clock wise to loosen.