It is held on by a small wire clip on the inboard side.
It is held on by a small wire clip on the inboard side.
It is held on by a small wire clip on the inboard side.
With a hammer and pry bar.
There is a small 'c' clip on the underside of the crank. A set of needle nose pliers are handy
inside the doors. you have to remove the inside door panels
Go to autozone, carquest, etc and buy a tool specifically designed to remove the crank. costs a few dollars
Were is the power window fuse and/or circuit breaker located in a 1999 dodge durango?
Take off your door panel and there is four bolts i believe remove them and it come s off pretty easy.
what do i do
How do you remove the manual window cranThere should be an Allen type set-screw in the base of the handle. It will be recessed, and you'll have to turn the crank to access it more easily. Remove the setscrew, and the handle slips off of the stud. If the window is down, and it begins to rain, you can roll the window up by holding it onto the stud, and turning, or you can use a small pair of vise grips. Just try not to damage the teeth on the stud.
Yes
All you need is a paint can opener. Under the window crank there is a horseshoe shaped pin and you just need to snag it and pull it out. Put down the window first and do the above. Then after romoving all the screws in the door panel lift up on it until it pops off.
1999 dodge intrepid is not starting I change crank and camshaft sensor and it stall will not start what can i do next.
Drivers Side Grounded to the block.