To remove the window crank on a 1999 Saturn, first, locate the small plastic cover on the side of the crank handle. Use a flathead screwdriver to gently pry off the cover, revealing a retaining clip or screw. If it's a clip, use a pair of pliers to squeeze and pull it off; if it's a screw, simply unscrew it. Once the clip or screw is removed, you can slide the crank off the window regulator shaft.
With a hammer and pry bar.
There is a small 'c' clip on the underside of the crank. A set of needle nose pliers are handy
To replace the window crank on a 1999 Chevrolet Prizm, first, remove the decorative cover if present by gently prying it off with a flathead screwdriver. Next, use a small socket or ratchet to remove the retaining screw that holds the crank in place. Once the screw is removed, pull the crank straight off the window regulator shaft. Finally, align the new crank with the shaft, secure it with the screw, and replace the cover if applicable.
Go to autozone, carquest, etc and buy a tool specifically designed to remove the crank. costs a few dollars
Take off your door panel and there is four bolts i believe remove them and it come s off pretty easy.
How do you remove the manual window cranThere should be an Allen type set-screw in the base of the handle. It will be recessed, and you'll have to turn the crank to access it more easily. Remove the setscrew, and the handle slips off of the stud. If the window is down, and it begins to rain, you can roll the window up by holding it onto the stud, and turning, or you can use a small pair of vise grips. Just try not to damage the teeth on the stud.
All you need is a paint can opener. Under the window crank there is a horseshoe shaped pin and you just need to snag it and pull it out. Put down the window first and do the above. Then after romoving all the screws in the door panel lift up on it until it pops off.
Lock up, No but a bad crank sensor will prevent the engine from starting.
The crank sensor is behind the starter. Remover the starter at the back of the engine and you will see the sensor
How to remove the window motor from the regulator
See link below:
Remove the inside door panel of your 1999 Chrysler Intrepid. Remove the window retaining clips. Put the window back into the window track. Secure the window with the window retaining clips.