0
Where is the crank sensor located on a 1999 Saturn SL2 and how do you change it?
Wiki User
∙ 11y ago
The crank sensor is behind the starter. Remover the starter at the back of the engine and you will see the sensor
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is crank sensor located for 2006 Saturn vue?
There is a video on U-Tube showing where the sensor is and how to change it. It is above the starter
Where is the Saturn 2000 l2 3.0 v6 crank position sensor located please help?
behind the crank pully
How do you change a crank sensor in a 95 Saturn?
The crank position sensor is located on the back side of the engine (the side that faces the firewall) slightly above the starter on the engine block at the number 3 cylinder. It is held on by one 10mm bolt and the wiring plugged into it. I would recommend removing the starter to change this sensor as it will be much easier.
Where is the crank sensor located on 1998 Bravada?
the crank sensor is located just behind the crank shaft pully of the engine.
Where do you find crank sensor on 2003 Saturn vue 6 cylinder?
The V6 in the Saturn VUE is sideways (FWD) vs. the version used in the Cadillac Catera (RWD). On the Saturn, the crank sensor is mounted on the front side of the engine, sort of near where the trans mounts to the engine. Pretty easy to change.
Where is the crank shaft sensor located in a Audi a4?
Where is the crank shaft sensor located in a Audi a6
Where is the crank sensor located on a '92 Saturn SL?
Hey Kevin==It depends on your engine but I think it is on the fromt by the balancer. GoodluckJoe the crank sensor is on the back of the block above the starter motor It has a green 2-wire connector to it.
Where is the crank sensor located on 1989 camaro rs?
That year did not have a crank sensor.
How do you change crankshaft position sensor?
where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace
Where is crank sensor located on 1997 Dodge Ram van?
the crank sensor is located on the top front of the tranny
Where is crank sensor located on 97 sebring lxi?
where is the crank sensor located on my 1997 Chrysler sebring lxi
If your crank sensor goes out how do you know which one to change?
There is only one crank sensor fitted, you may also have a cam sensor. the crank sensor is located either around the bellhousing or around the front crank pulley. It either has 2 or 3 wires. It picks the signal off the revolving crank so look for a sensor in the block near flywheel.
