look at the half circle clip on the side of wiper arm. lift the wiper arm and pull the clip out as far as it goes the wiper arm should rest on the clip and now be "locked" up in the air . now you should be able to remove the wiper arm
The 1993 Jeep Grand Cherokee takes 20" replacement windshield wiper blades on both sides front and an 11" or 12" rear wiper blade.
Where is the windshield wiper relay located on a 1996 grand jeep Cherokee
On a 1994 Grand Cherokee, it is located behind the driver-side kick panel. Maybe that will get you started.
They are both located under the plastic wiper cowl in the area between the hood and windshield. Remove the wipers (if you aren't sure how to do that you pull the tabs about 3/4 of the way out) then you remove the screws in the wiper cowl. Once it is removed you should see both the wiper motor and control bar.
Yes. It's the same setup.
The 1994 Jeep Grand Cherokee takes 20" replacement windshield wiper blades on both sides front and a 10" or 11" wiper on the rear.
Jeep Grand Cherokee was created in 1993.
Do you live in an area that you need your heater?
1993 Jeep Cherokee Ignition Wiring ...
The 1999-2000 Jeep Grand Cherokee takes 21" replacement windshield wiper blades on both sides front and an 10" or 11" rear wiper blade.
The 1994-1998 Jeep Grand Cherokee takes 20" replacement windshield wiper blades on both sides front and an 10" or 11" rear wiper blade.
theres a clip. unclip it. use a small screwdriver to push the clip out and pull it out.