Best Answer

They are both located under the plastic wiper cowl in the area between the hood and windshield. Remove the wipers (if you aren't sure how to do that you pull the tabs about 3/4 of the way out) then you remove the screws in the wiper cowl. Once it is removed you should see both the wiper motor and control bar.

User Avatar

Wiki User

โˆ™ 2009-11-29 03:14:47
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you access the windshield wiper motor and control bar of a 1993 Jeep Cherokee?
Write your answer...
Still have questions?
magnify glass
Continue Learning about Music & Radio

1997 Jeep Cherokee blower motor relay location?

The Bower Relay on my 97 jeep Cherokee xj is located behind the glovebox. The glove box will hinge down allowing access to the relay by removing the rubber stops on the glove box opening. The relay is attached in plain sight to a plug with about five wires.

What is the stock gear ratio for a Jeep Cherokee?

Stock gear ratios will vary for a Jeep Cherokee depending upon the size of the motor. However, 3.55 and 3.73 are two common gear ratios for the Jeep Cherokee.

Does a 1995 Jeep Grand Cherokee Limited have a zero clearance motor if the timing chain breaks?


How do you replace the radiator fan control relay on a 1999 Jeep Grand Cherokee Laredo?

The radiator fan control relay on the 1999 jeep grand Cherokee Laredo is located BEHIND the passenger side front head lamp housing through a cut out square hole. You gain access to the fan motor relay by initially following the instructions for changing a head lamp bulb in the owners manual. Once you detach the head lamp housing from vehicle frame, look through the square hole in the frame. The OEM relay has a square sky blue labling. It's recommended that you apply electrical grease to surface in order to help prevent corrosion, moisture, and enhance conductivity when replacing. where is the emission control system in my 1999 jeep grand Cherokee Laredo?

How do you test a blower motor on a 1997 Jeep Cherokee to determine if the resistor or the motor is bad?

spin the motor, if its raspy or rough, any play in it, replace it! i should have done that first! i went through 2 resistors. im bummed!

Related questions

Where is the wiper control module for a 2001 Chevy Cavalier?

Its attached to the windshield wiper motor you will have to remove the cowl to get access to it.

What could be wrong with a 1991 jeep Cherokee if just the windshield wipers went out?


Where is the windshield wiper control module?

The windshield wiper control module is usually in the fuse box located in the engine compartment of most automobiles. Sometimes the windshield wiper control module is located on the firewall next to the windshield wiper motor.

On a 1995 Jeep Cherokee where is the switch that controls windshield wiper speeds?


Where is the windshield wiper control module for a 2000 Malibu?

in the front side of the wiper motor

How do you change the wiper motor on a 1991 Jeep Wrangler?

The windshield needs to be folded into the down position to access the wiper motor. There are a couple cut-outs in the metal of the cowl that allows access to the wiper motor & linkage. There are release bolts on either side of the windshield & of course the top needs to be off.

Where is windshield wiper control module on 2002 trailblazer?

on the bottom of the wiper motor. its where the cables plug into

Does one motor control both windshield wiper blades on a 1997 Nissan Sentra?


What causes slow windshield wipers on a 1994 Jeep Cherokee I replaced the wiper motor but there was no change.?

Weak battery or alternator output.

Where is the access panel to the fan motor for a 1998 Jeep Grand Cherokee?

Fan motor should be located at the passenger side firewall

How do you access backside of engine in 98 Plymouth Voyager?

If its like a 96 you remove the windshield wiper motor and assembly

How do you access and change the windshield washer motor pump in a 1992 Chevrolet Cavalier?

It is located in the washer fluid reservoir.

People also asked