answersLogoWhite

0

Depends on the exact maker and model.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you change headlight bulb 2003 Concorde?

From inside of the engine well, remove the soft rivets from in front of the hood release. Use a 7mm ratchet to remove the housing bolts. Remove the bulb housing, wiggling if necessary. The bulb housing turns counter clockwise to detach from the housing. Replace the bulb, housing and soft rivets.


If the trigger housing on your Browning 7mm mag auto loading rifle has cracked and needs to be replaced is it covered under warranty?

We can't answer that question for you. Contact the Browning service center. Have your model and serial number available. Browning Service DepartmentOne Browning PlaceArnold, Missouri 63010-94061-800-322-4626


What is the age and value of a Browning M70 semi auto 7mm mag with serial number 65623?

Browning does not make a M70 semi auto 7mm nag


What is the value of a Browning 7mm automatic gold trigger?

100-1000 usd


Bar semi-auto 7mm mag series57783m70?

Fine weapons


Browning 7mm magnum?

Made in both Bolt and Semi-Auto versions


When and where was the first auto rifle used?

Mexico, 1887- the 7mm Mondragon rifle


How do you replace the blower motor resistor in a 99 Tahoe?

Remove the glove box. The Blower Motor Resistor is on top of of the large black hvac housing. It is held by 2 - 7mm hex head screws. Very hard to get your hand in there to remove them. Connector is on top.


How do you remove bolt from browning 7mm?

Best left to a gunsmith.


How do you replace the front turn signal bulb located on a 1994 Chevy Cavalier?

If it is a front bulb, sometimes you can get to the bulb and remove it by turning it counterclockwise. If it is the rear you have to remove the housing and then remove the bulb. Remove the (4) 7mm Hex screws that fasten the wheel well liner. Pull the liner back as needed. Then reach in and remove the bulb by twisting the connector to release the connector and bulb from the turn signal housing. Pull the connector back towards you and replace the bulb.


How do you change the rear signal light on Pontiac aztek?

open the rear hatch, and remove two 7mm bolts, carefully remove the housing. once removed do not hang by wires. push tab and twist bulb assembly. pull bulb strait out and re-install


What is the agemodeland value of a Browning 7mm serial 3L22686?

Need to know if its a bolt or semi-auto.