How to remove drivers' side light cover
unscrew the light from the spoiler Disconnect the water hose Viola
Does the symbol of the car appear to have its boot open? If so, it means your boot or hatch isn't closed properly. Close it properly and the light should go out.
remove bulb from in side the boot
Jack it up and get out the wheel brace from under the boot floor then loosen all 5 nuts and pull. Simples
I've got to change mine as well, but its a 2004 model. I've been told to open the boot & remove carpet /insulation lining to gain access to the lamps . Hope it's the same for your model!
how do you remove the shifter boot in a 2001 hyundai tiburon
on the v70 estate its in the boot on the near side if its rhd
Open the cover of the boot lid - from there on you should see the bulb socket ==New Answer Headline== Have just figured out how to replace a bulb in the license plate light of my 1999 S40. Not sure if it is exactly the same as the 2000 model but here goes. Open back the trim on inside of boot lid so that the two license plate lights are visible. (They are located on either side of the boot lock). Locate the two wires that are connected to the bulb holder which projects from the back of the light. On my S40, the bulb holder is black and conical and appears to be an integral part of the light assembly but can be removed by squeezing either side and pulling directly back out of the light assembly. To make removal of the bulb holder easier, you can first disconnect the two wires from each holder. As you remove the bulb holder, be careful not to drop the holder and bulb into the sapce between the reinforcing metalwork on the inside of the boot! Remove old bulb, and fit new one into bulb holder, push holder into back of light assembly and check that it works before replacing into back of light assembly and replacing boot trim! If for some reason you need to repalce the entire light assembly, first remove the external panel that contains the boot lock and runs along over the license plate. Do this by unscrewing the four nuts on inside of boot lid that hold panel in place. Light assembly can then be removed by pushing from inside to outside after pressing on internal plastic retainers that are part of light assembly.
>>>>>>>
remove the console, you should see some screws on the bottom of the boot, remove, replace boot, replace console
In the boot