undo the hoses and should only be a few screws to loosen to take it off, should be very easy
Take off the washer fluid bottle.
The washer fluid for the rear liftgate is supplied by the same reservoir as the windshield in a 2000 Mercury Villager
The washer pump has probably failed or is plugged with dirt.
On a 2000 Mercury Villager : The washer fluid for the rear liftgate is supplied by the same reservoir as the windshield ( located in the engine compartment )
To replace the washer fluid reservoir on a 1997 Mercury Villager, first, disconnect the negative battery terminal to avoid any electrical issues. Remove the necessary components to access the reservoir, such as the front grille or any obstructing plastic panels. Disconnect the washer fluid hose and electrical connector, then unbolt the reservoir from its mounting points. Finally, install the new reservoir in reverse order, reconnect the hose and electrical connector, and refill with washer fluid.
The 2001 Villager washer fluid level sensor is inside of the washer fluid reservoir. The sensor can be access through the bottom of the washer fluid reservoir.
Your washer fluid is low, or the indicator is stuck. The washer bottle would have to be removed and checked.
In the 1997 Mercury Villager, the Transmission fluid dipstick is located on the driver's side of the engine just in front of and below the master cylinder/brake fluid check. The 97 Villager has a bulbous knob on top with no indication that it is the Transmission fluid.
Begin by removing the washer fluid tank hoses from your 1998 Oldsmobile And tree. Remove the washer fluid tank retaining bolts. The washer fluid tank will come off.
The washer fluid for the liftgate is supplied by the same reservoir as the windshield
2004 Chevy Cavalier windshield washer fluid reservoir retaining bolts. Remove the windshield washer fluid supply tube. The windshield washer fluid reservoir will come free.
Just normal DOT3 brake fluid.