you have to brush it
You could try to use nail polish remover. Try google searching other answers ...
there are many ways you can. you can use a name brand stain remover, like SHOUT. or you can hand wash it with regular soap.
Nail varnish remover
Folex works great
You have to break the motor down to the armature (bit runs through middle) and stator the coil. cut all the copper from one end of stator. stand the stator on its pre-cutt end place wood in to the center of the stator and set fire to the wood ensuring all the varnish/resin is burnt away on the stator . then with tongs or pliers remove the looped ends of copper by with drawing the strands from their respective groves
Sometimes wood needs to be re varnished or restrained. To remove old varnish, you can use either a paint stripper or sand off the old varnish.
This depends upon the type of material. Varnish is best for wood.
Applying varnish to wooden floors is a very good idea , but before doing so make sure to clean the room out , remove any furniture , and sand down to the bare wood to make sure any traces of old varnish , if used previously , is gone .
You'll need to use some lacquer thinner and a wire brush to remove any varnish on brick.
There really isn't a way to remove a paint thinner stain from wood furniture. You must repaint or re-stain the furniture.
Goo Gone will remove it
The process of wood finishing refers to the final stages in protecting and sealing wooden items. This may be the protection of wooden furniture with varnish, for example.
first remove the od finish. or you can use with chemical liquid to remove it. remove the physical surface of furniture, and than you can use wood putty to make that surface and than refinish the furniture
how to get clay off wood tables.
For wooden furniture, varnish would leave it looking much better than regular house paint, but it can be a little more expensive. Regular housepaint won't look bad, but may not be as attractive as a varnish finish would be.
To refinish a piece of furniture you can sand it down and then apply an even coat of varnish to it. It will seal it nicely and look like it's brand new.
Goo Gone will remove almost any sticky label without hurting the wood.