Remove the wheel, remove the brake caliper, remove the brake rotor, disconnect wheel speed sensor from harness. remove the bearing hub, remove the wheel speed sensor from the bearing hub. Reverse order for install.
If it is equipped with air bags of course it has sensors.
In back of engine, it can be reached from the top.
There are four o2 sensors on a 1996 Chevy blazer all on the exhaust, of course, there are three ahead of the convertors and one between the convertor and muffler. on the right hand bank. should be changed every 60,000 miles.
I have a code DTC P0154.Bank 2 Sensor 1 no activity.Which sensor is this on my 96 Blazer?
36mm
Their are two sensors located directly behind the front bumper along side of its mounting brackets.
There are many sensors that can trip the check engine light to come on.
It should be located on the front of the water pump.
The firing order for a 1996 Chevrolet S10 Blazer is 1, 6, 5, 4, 3, 2. The number one cylinder is on the front right as you face the engine.
It can be done, but you would need the core support from the Xtreme, as well as the grille, bumper, and other front end components.
1996 Chevy blazer timing chain
Power seat relay location for 1996 Blazer