0
What else can I help you with?
What is the firing order for a 1969 Buick Skylark?
I think it is 18436572 usually stamped on intake manifold on the old Buicks.
Where are the fuel injectors located on a 97 Buick Skylark?
On a 1997 Buick Skylark, the fuel injectors are located on the intake manifold, mounted directly to the engine. To access them, you typically need to remove the intake manifold cover and possibly other components, depending on the specific engine configuration. The injectors are positioned in the intake ports, where they spray fuel directly into the air entering the engine.
Where is the tps on 98 Buick Skylark?
On a 1998 Buick Skylark, the throttle position sensor (TPS) is located on the throttle body, which is situated on the intake manifold. To access it, you may need to remove the air intake duct. The TPS is typically mounted with screws and connected to the vehicle's wiring harness. Make sure to disconnect the battery before attempting any repairs.
About how much does it cost to repair the head gasket on a 1993 Buick Skylark?
I have a 1995 Skylark and that repair is at least $500.00 but it's worth it. The engine runs great now.
Will front fenders from a 1971 Buick Skylark Custom fit a 1972 Buick Skylark?
will the fenders from a 1971 Buick Skylark Custom fit a 1972 Buick Skylark?
What is bolt torque for lower intake manifold for 97 buick lesabre?
The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.
When was Buick Skylark created?
Buick Skylark was created in 1953.
How do you replace the water heater inlet pipe on the intake manifold on a 3800 buick lesabre?
replace the water heater inlet pipe on the intake manifold on a 3800
How do you fix the radio in a Buick Skylark?
The most descriptive answer is in a Chilton's or Haynes repair manual. Amazon has them cheap.
What is the torque spec for 2004 3.8 Buick lesabre lower intake manifold?
The torque specification for the lower intake manifold on a 2004 Buick LeSabre with a 3.8L engine is typically around 11 lb-ft (15 Nm). It's important to follow a specific tightening sequence in multiple steps to ensure even pressure across the manifold. Always refer to a repair manual for the precise procedure and torque sequence for your specific vehicle.
Where is the oil filter located on a 91 Buick Skylark?
it is between the fire wall and passenger motor under intake manifold closer to passenger side i think it is a Valvoline v-111 but can be done with a cap wrench filter tool it was difficult to do from the top
How much does a Buick skylark weight?
hw much does an 81 buick skylark weigh?
