You must replace them they are sealed and cannot be serviced.
a hub is what the wheel bolts to on the car.the hub bearings are the bearings that allow the hub to turn on the axle. most times they are called axle bearings,
The hub bearings in a 1998 Z71 can not be repacked. The bearings are part of the hub, and the hub assembly will have to be replaced.
When you remove the front wheels on a vehicle, there is usually a cap on the center of the 'hub'- the part you removed the wheel from by loosening and removing the wheel nuts. If you remove that cap with a flat screwdriver or other small pry bar, you will see the hub bearings inside. They are usually roller bearings that have grease all over them. You should read a repair manual if you are going to remove them and/or replace them.
No, the hub is the outer housing that the bearing sits in. Usually bearings have to be pressed in and out of the hub.
In most cases, yes.
You have to pull that whole assembly apart to get to the bearings. The wheel comes off, then the brake rotor, then you have the hub assembly. The bearings are inside of that.
They need to be pressed in. You will have to remove the hub assembly and have a shop press the bearings into the hub.
When they get noisy.
front hub assembley front hub assembley
It has 1 big hub bearing per side and you can not service them. It has factory sealed bearings. If there bad then you must replace the bearing.
front hub 120nm i think
Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier