the oxygen sensor is located between the fist and second muffler. you will need to disconnect the sensor and it will then unscrew out of the exhaust pipe. I just did this on my H6 and I also needed to replace the air mix sensors on each side of the motor. they look just like oxy sensors and my need to be replaced as well. they are located on either side of the headers. the best way to get at them is from under the hood. you will also have to disconnect these sensors from the top and then unscrew them from the headers on each side.
Where is the bank2 sensor 1 located on a 2001 subaru outback 3.0
Unplug sensor--- sometimes you can get a wrench on the sensor if not you will have to purchase the special socket.Genuine parts are often high so you can get the sensor at an auto store directions are included with the sensor as how to attach the pigtail and ude the heat shrink tubing suppied
I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters. I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters.
that the knock sensor does
Throttle position sensor on this vehicle is held on by two screws. It's a 10 minute job.
there are two. both along the exhaust under the car. one just before the catalytic converter and one just after.
The function of the oxygen sensor in a Subaru or any other car is to measure the amount of oxygen that is mixed with exhaust gases.
When a Subaru has a faulty O2 sensor the fuel management is out of whack.
Directly below the alternator on the block.
P1137: Front O2(oxygen) aka A/F(air/fuel) Sensor Circuit Range/Performance Problem.
on top of the engine under the air box
It is located on the engine block drivers side.