0
What else can I help you with?
How do you replace the throttle position sensor in a 1993 subaru impreza?
To replace the throttle position sensor (TPS) in a 1993 Subaru Impreza, first disconnect the negative battery cable to ensure safety. Locate the TPS on the throttle body, disconnect the electrical connector, and remove the two screws securing the sensor. Install the new TPS by aligning it properly, securing it with the screws, and reconnecting the electrical connector. Finally, reconnect the battery and check for proper operation.
What is a TPS a 2.2 liter engine for Subaru 1997 legacy?
"TPS" = Throttle Position Sensor. It's the sensor that tells the computer how far your foot is into the throttle. It should be connected to the butterfly valve that opens to allow more air into the engine.
How do you adjust tps on1999 Chevy Malibu?
NO ajust on tps sensor,. Replace
How do you adjust the tps on a Honda Civic?
you dont, you replace it
Where is TPS in Chevy caprice 1989 and what you have to do when you get code 22-TPS signal voltage low?
tps will be located other side ofthrotle to accel cable check for clean connection at tps plug replace tps unless you can test unit dave.cop
How do you replace 1994 mercury villager tps cable?
TPS usually means throttle position sensor, and it doesn't have a "cable".
How do you replace tps on Dodge Durango?
Check out something for the Throttle Position Sensor (TPS) in the askjeeves.com website. They have a lot of useful info.
Where is the TPS located on a Chevy Diesel?
On my 1997 Silverado the TPS is right in the accelerator pedal. Look close at your pedal for the wire and plug in module.
How do you replace a TPS on 2001 Buick Regal?
i would recommend eBay
Where is the tps located in a 1997 gmc safari?
I believe it is on the side of the throttle body.
Where is the tps on 1997 Pontiac Grand Am 4-cylinderinder?
Where is the throttle position sensor on a 1997 pontiac grand am 4 cyl.
How do you replace the tps in 1990 Chevy Celebrity?
To remove the throttle position sensor: 1. Unplug the electrical harness. 2. Remove the bolt that holds the tps in place. 3. Remove the tps. To install a new tps reverse the removal procedure. There is no adjustment given.
