0
I'm going to guess that its the same as the 2007 MDX. There is a black trim that the license plate lights recess into. You will need to remove the 5 or so screws and remove the rear view camera cover if you have one to get to the remaining screws. Once the screws have been removed you will need to bend the trim slightly to free the tabs at both ends. Once the trim has been removed you will see the light covers. The covers have lips on one side to push and release the cover latch. I had a little trouble and used a flat screwdriver to help remove the cover. Once the cover is removed you will have access to the bulb. Do everything in a reverse order to put it back together.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace license plate bulb on 2008 Pontiac G8?
You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825
How do you replace license plate light bulb on 2008 Honda Odyssey?
05+ Honda Odyssey license plate lights. Pop out the license plate lights in the rear. There are two of them. Use a very thin flathead screw driver and pop out the sides of the inner clear light assembly. They are on the sides. Once that is done, remove the light bulb and replace with a new bulb. Pop in the clear light assembly cover. Turn on lights to see if the bulb is working and it is is then you're done. Approximately 10-15 minutes total.
How do you replace the license plate light bulb on a 2008 Cadillac STS?
if your under miles its under warrenty
How do you change license plate bulb on a 2008 subaru legacy sedan?
The 2006 Legacy license plate bulb is accessed by removing the liner in the trunk and un screwing the plastic socket.
How do you remove front license plate bracket 2009 Mercury Mariner?
It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.
How do you replace tail lights and brake lights on a 2008 Ford F-350?
4 screaws remove lences
How do you replace a side marker bulb on a 2008 Saturn vue?
How do you replace the side marker lights on a 2008 saturn vue?, they seem to be hid completely in the body.
How do you replace marker lights on a 2008 gmc Yukon Denali?
You can replace the marker lights on a 2008 GMC Yukon Denali by removing the retaining screws and disconnecting the wiring harness. The bulb can then be unscrewed and a new bulb put in place.
How do you replace Trailblazer interior lights?
how do you remove dome light lens on 2008 trailblazer
Why does your bright lights work and your head lights dont on a 2008 Chevy Cobalt?
High and low beams have differant filaments. You have to replace the bulbs.
Install fog lights on a 2008 Nissan Altima do you replace turn signal switch as well?
yes
Where is the block heater on a 2008 Ford Escape?
On my Escape XLT, you reach up under the front license plate. Ther cord is there with a nice cap on it. On my Escape XLT, you reach up under the front license plate. Ther cord is there with a nice cap on it.
