Remove base from roof, cut old wire, tape it SECURELY to the new wire and pull it down through the pillar from under the dash. If you lose the wire pulling it through it can be a pain to get the new wire into place.
unbolt it and then remove it. Put new one in then tighten it up
no
fgcffcf
YES
The Oxygen sensor of a 89 honda accord lxi fuel injection 2.0 valve engine is located in front of the engine on the manifold .
== ==
With enough modifications anything is possible.
They should fit as both years are the 3rd generation Accord.
Bad spark plug wire or distributor cap. Replace them both plus the rotor.
any engine will work with a little mod or alot of mods i wouldnt do it 86-89 honda accord should work
It should be 33 to 39 psi
u face the spring towards the engine