answersLogoWhite

0

What else can I help you with?

Related Questions

Change ignition lock on 1970 ford maverick?

How do I replace an Ignition in a 1970 Maverick


How do you replace the key ignition switch in a 1970 Chevelle SS?

several special tools are REQUIRED to perform this task, which involves removing the steering wheel.


1970 Chevrolet high speed blower switch not working?

replace the switch.


How do you replace the headlight switch on a 1970 Chevelle Malibu?

any pictures of headlight switch replacement of 1970 chevelle ss


How do you replace a 1970 Chevy ignition coil?

take the wires off the + and - side of the coil, pull the coil wire out of the coil, unbolt the coil from the manifold, to install just reverse directions.


1970 camaro you have power to the dist with key on but you loose it when cranking the key?

change the ignition switch.


How do you replace the ignition switch located on a 1971 Chevy El Camino with tilt steering?

The ignition switch is located on the steering column just above the brake pedal. it has 2 screws holding it in place. You will need to take the entire steering colum off. Pull the wiring harness out.. it's a real pain. I own a 1970 SS 396 cowl induction, factory air, everything stock. It's an orignal. == == Your car has a Rack and rod setup. When the key is turned it pushes the rod down the steering column and slides the ignition switch into the position you want. To replace it you need to remove it from the bottom of the steering column. There should be either two screws or a clamp.


Where can you find a turn signal switch for a 1970 Chevy G20 van?

Steering colum


Where is the ignition module on 1970 Chevy C10 with a 350 that has a HEI distributor?

under the rotor on the inside of the distributor cap


What is the ignition timing for a 1970 Chevy 454?

timing for the 454 engine is 10 degree's at TDC at 700 rpm in neutral or park


What is the best spark plug for a 1970 Chevy 350 engine?

ACDelco R45S conventional spark plugs for an original ignition system.


Ignition timing for a 1970 402 big block Chevy?

There are contributing factors, however, about 6 degrees advanced or BTDC., should work best.