Question isn't clear. Are you asking how do you replace the bulb -OR- how to remove the entire lens assembly?
Because the Toyota Highlander is a Japanese car.
Depends on the year. On the 2002 there is a removable plastic door in the rear cargo area. The tailights are easily accessible and twist out easily.
2003 Toyota Highlander tail light bulb lamp replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
with alot of expirience :)
Replace the light bulb. Tail lights are usually dual filament, 2 filaments in one bulb.
eassy pull the fuse box cover off turn it over located the tail light fuse pull it out replace with same amp fuse
How do you change the tail light on a 2001 toyota sequoia
If it's just a bulb replacement, Open the tailgate look inside panel there should be torqs screws remove thelm. the entire tail light assy. comes out, replace the bad bulb and reinstall assy.
In order to replace the rear window tail light you need to get into the truck. Once inside the trunk look to the top of the trunk and look at where the screws are for the rear tail light. Unscrew them and the entire housing for the light will pop off.
you don't replace the tail light you just replace the bulb in it
To replace a tail light on a Toyota Echo, you will first need to access the tail light assembly from inside the trunk. Locate the back of the tail light assembly and remove any screws or fasteners holding it in place. Carefully disconnect the electrical connector, then remove the old tail light. Install the new tail light by reversing these steps, making sure to securely fasten the assembly and reconnect the electrical connector.