Headlights Tail and Brake Lights
Chevy Blazer
DIY Projects

How do you replace a brake light?

151617

Top Answer
User Avatar
Wiki User
2006-06-23 23:07:51
2006-06-23 23:07:51

Depends in the car ,if is an older model the lenses sould have screws,take the screws out and replace the bulb,if the car in newer open the trunk,move the inside liner to the side and you should be able to see it from there.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.

User Avatar

How to replace a brake light on a nissan Tiida hatch back.

User Avatar

To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.

User Avatar

how to replace the brake light switch at the pedal of a 2001 ford zx2

User Avatar

how to replace brake light bulb fiat doblo van

User Avatar

Your brake light is probably brake fluid low or emergency brake on. Rear brake lights are replaced by removing the lens and replacing the dual filament bulb.

User Avatar

How do you replace the third rear brake light in a 2005 buick allure

User Avatar

Pull the carpeting behind the brake light. Unclip the assembly, replace bulb.

User Avatar

How do you replace the rear brake light bulb on a 2001 Honda civic?"

User Avatar

To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.

User Avatar

How do you remove cover to replace brake light on 57 kia Rio

User Avatar

you need to replace the brake light switch that is located above the brake pedal underneath the dasboard Here's a link to a video that 1aauto.com has that shows you how to replace the brake light switch.

User Avatar

Check the brake light switch on the brake pedal. Might have to replace it.

User Avatar

How can i replace my middle brake light on my 2005 kia sorento.

User Avatar

you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light. you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light.

User Avatar

How do i change the 3rd brake light on a mercedes vito van.It is the brake light above the back door?

User Avatar

replace brake light switch on brake pedal

User Avatar

To replace the brake light on a 2001 Dodge Durango the light lens must be removed. It is held on by a clip on one side and a hinge on another. It opens like a door to access the brake light housing.

User Avatar

Its located on the brake pedal. Unplug the wiring harness and unbolt it and replace it.

User Avatar

You can try to reset your brake light switch by unplugging the brake light switch and plugging it back in. If that does not solve your problem you will need to replace the brake light switch.

User Avatar

The brake light assembly can be access through the cargo compartment. Remove the cover to the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. The brake light will come out. Reverse the process to install the new brake light.

User Avatar

To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.