Verry carefully... It's not hard, the only tool needed is a pair of needle nose pliers to pull the lime green retaining pin out. Remember how you pulled it apart as it will go together a few ways but there is only one correct/safe way, so that it cannot come apart later. If you need the switch the Ford PN is F87B-13480-AB
replace brake light switch located on brake pedal under dash
you need to replace the brake light switch that is located above the brake pedal underneath the dasboard Here's a link to a video that 1aauto.com has that shows you how to replace the brake light switch.
how do i replace the fuel selector switch on the dash of a 1995 ford f250
How to replace spedo cable f250
Check your brake light switch. It's about 3-4 inches up the arm of the pedal. Chances are that's the problem.
Lift the car, remove the tire, remove the brake shoes/calipers, remove and dispose of the old pads. Put in the new pads, replace the brake shoe/caliper, replace the tire and lower the car.
Lift the vehicle with a jack, remove the tire, remove the caliper/brake shoe, remove the old brake pad. Dispose of the old brake pad properly, put in the new brake pad, replace the caliper/brake shoe and replace the tire, then lower the vehicle to the ground.
According to the 2004 Ford F-250 Owner Guide the heated outside mirrors are heated automatically , there is no switch to turn on
On a 2004 Ford F-250 : The multifunction switch is INSIDE the steering wheel column cover ( the turn signal lever and the hazard flasher button sticks out of the steering column cover )
Jack up the F250's front end. Remove the wheel. Remove the locking assembly, this will be different depending on which assembly is used (skip this step it the F250 has the slide on type rotor.) Unbolt the brake caliper and swivel it out of the way. The rotor was either unbolted during the locking hub removal, or it is the slide on type that will now just pull off.
The fuse box is located on the inside of a 2004 F250. The fuse box will be found in the floorwell.
good question. you do not adjust cable on emergency brake in 2004 f250. the emergency brakes are drum type brakes inside the rear brake disk on each wheel.if you know how o adjust drum brakes it is the same adjustment for emergency brake on this vehicle. on the back of the drum there is a small rubber cap. remove this cap and with a flat screwdriver or adjuster tool, you turn the the serated wheel inside the brake drum to adjust the brake shoes out till nearly touching the brake drum it is best to do this with the rear wheels jacked up off the ground, so you can spin the wheel while adjusting. by spinning wheel you will feel when brake shoe is starting to slow wheel and you will then know to stop adjusting. do this on both wheels if you over adjust you will burn brakes out and have to replace brake shoes. this is a pain as you have to remove the disk brake caliper and rotoar to get at the emergency brake