Car Computers and Sensors
Pontiac Bonneville
VW New Beetle
Crankshaft Sensors

How do you replace a cam shaft sensor and where is it located on a 1990 Pontiac Bonneville?

899091

Top Answer
User Avatar
Wiki User
2015-07-15 21:35:27
2015-07-15 21:35:27

The cam shaft sensor is located behind the water pump pulley. One bolt that holds it in place.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is a knock sensor located on a 96 Pontiac Bonneville

User Avatar

Where is the crank shaft located on a 1999 Pontiac Bonneville? I have bought the part. Just can't find where it goes.

User Avatar

where is a map sensor loction for 1994 ponatic bonneville?

User Avatar

it should be on the right side right neer the belt

User Avatar

You got to have a star bit with a hole in the middle the mad is on top of the air duct

User Avatar

Please answer the question. "How do you change an oxygen sensor in a 2002 Pontiac Bonneville

User Avatar

one location of map sensor on some pontisome Pontiac Bonneville,s map sensors are located in the vicinity of the pcv--valve, over top of it , depends on year.

User Avatar

You can find the PCV valve beneath the MAP sensor located in the plenum at the right front of the engine.

User Avatar

The sensor is located on the right side of the the crankshaft attached by 2 bolts thru the timing cover it will be hard to see due to the pulley.

User Avatar

The blower motor on a 1997 Pontiac Bonneville is located next the evaporator core. It will be mounted behind the glovebox on the passenger side of the vehicle. Remove the glovebox, mounting hardware, and sensor clips. The blower motor will be able to be replaced.

User Avatar

Typically the O2 sensor is located at the back of the engine, follow the exhaust manifold and it should be attached somewhere near it

User Avatar

on a 93 Pontiac Bonneville you would remove the passenger side front tire. there may be a plastic cover that just pulls off. look to your left,back and up a little bit you should see the wires that connect to your cam sensor. theres your cam sensor. 91 Bonneville is probably the same.

User Avatar

unclip the old one, unscrew it. then screw in the new one and clip the new one on

User Avatar

my son just replaced one on my car i also have a 1992 Bonneville it is located on the passenger side frount behind the tire you will need to remove your tire

User Avatar

Try looking at the back of the engine on the maifold just before it connects to the exhaust pipe.

User Avatar

The cam sensor on a 1987 Bonneville is just below the water pump, it has a gray electrical connector.

User Avatar

Is it hard to remove / replace the sensor Speed sensors are located on the front wheel hub

User Avatar

On the intake manifold near the thermostat housing. It will be two wires a yellow and one black wire.

User Avatar

where is oil sensor located on g6 pontiac 2006 gtp

User Avatar

It is on the intake manifold near the thermostat housing.

User Avatar

If it's the same as a 1999 model, the outside temperature module is located in front of the radiator and behind the front bumper.

User Avatar

There are two oxygen sensors, there is one located in the exhaust system before the catalytic converter and one after the catalytic converter.

User Avatar

code 32 -1987-Pontiac bonevillecode 32 on 1987 Pontiac Bonneville -means-Baro sensor or circuit(carbureted models)or if(fuel injected model)means-EGR circuit

User Avatar

These fans work off of heat sensors. Your sensor can be failing, replace this sensor. This still does not tell where the sensor is located.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.