0
disconnect wires and label them,each coil has its own screws holding it to plate,take out scews,pull coil straight up do not bend the coil tangs at mounting of coil. Do this for each coil! HOPE THIS HELPS!
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the coil pack located on a 1998 Chevy Malibu with 2.4 engine?
Where is the coil pack located on a 1998 Chevy Malibu with 2.4 engine
Why your 2000 Chevy Malibu vibrates in drive and not in park?
check your coil pack - mine had the same issue before.
What is the cause of a p305 code on a 2000 Chevy Malibu?
cylinder 5 missfire detected. could be plug, wire, or bad coil...
What would cause a miss fire in a 1998 Chevy Malibu after you change plugs wires and coil packs?
i would like to know what would cause the miss firing in Chevy Malibu
How do you replace the coil pack in a 2000 Camry?
How do I get to the bottom bolt on the coil pack of my 2000 Camry
Is it difficult to replace a MAP sensor on a 1998 Chevy Malibu?
its not real hard but to replace the map its easier if you remove the coil packs four bolts and three plugs then two 9/32 screws a vacume line and one plug
The coil keeps going out on a 1984 Chevy pu 350?
Next time you replace the coil, test and if necessary replace the resistor.
How do you replace the coil springs on a Pontiac grand am 2000?
change front coil spring on 2000 Pontiac grand am
2001 Chevy Malibu will turn over but will not fire?
Check the Malibu crank position sensor and coil pack. One of these is the most likely cause of the loss of fire.
How do you replace coil on plug for 2000 ls?
test
What is the spark plug firing order for a 2000 Chevy Malibu v6?
Firing order is 1-2-3-4-5-6, but the car has coil packs, so look at the link below left.
Do you have to replace a coil when replacing electroinic ignition in a 327 chevy motor?
no
