Fuel Filters
Buick LeSabre
Crankshaft Sensors

How do you replace a crankshaft on a 1992 Buick LeSabre?

262728

Top Answer
User Avatar
Wiki User
2015-07-15 20:58:59
2015-07-15 20:58:59

If you have to ask this question, you aren't qualified to do it yourself. The entire engine has to be removed from the car and completely disassembled. Sell it, and get a different car.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Loosen the tensioner pulley on your 1992 Buick LeSabre. Take the serpentine belt off. Put the new serpentine belt on and tighten it down with the tensioner pulley.

User Avatar

It is important to know the cost of replace the parts of a car while owning it. The average cost to replace brake pads and rotors to a 1992 Buick LeSabre as a kit would be about $300.

User Avatar

The 3.8 litre V6 engine in a 1992 Buick LeSabre has a timing CHAIN

User Avatar

Yest, the Buick LeSabre from 1992-1994 is the same exact car, inside, outside, underside. Everything is identical, except say for the trim packages and options you get on them. Therefore, yes the cassette radio from a 1992 LeSabre will work in a 1994 LeSabre.

User Avatar

replace the combination switch on the turn signal stalk

User Avatar

Yes, the 1992 Buick LeSabre does have driver side air bags. the air bags were standard in all the Buick cars that year.

User Avatar

A 1992 LeSabre wouldn't have a valet switch

User Avatar

i need wiring diagram for 92 buick lesabre

User Avatar

what color is the smoke. What does it smell like?

User Avatar

A fuse diagram for a 1992 Buick LeSabre is available from several auto part store chains. These stores have access to online automotive databases that store troubleshooting and repair information for most vehicles.

User Avatar

Three on the front of the engine and three at the rear.

User Avatar

replace heater core on 92 buick century

User Avatar

The crankshaft position sensor, on your 1992 Buick regal 3.1 liter, is located on the back of the engine. The crankshaft position sensor is on the inside of the engine cover.

User Avatar

Would have been built for R12, can be converted to R134a.

User Avatar

there is a rattling noise in the area of the serpentine bell

User Avatar

In the liquid (low pressure) line at the condenser connection.

User Avatar

If it is the same 3800 engine as the 1993 Lesabre--very simple. Alternator is right on top of the engine. Loosen the serpentine belt ( tensioner) - remove the mounting bolts that hold the alternator on the bracket- remove the wire connections.

User Avatar

No but it does take some weird angles to get to all of the bolts. It should remove without removing the motor mount.

User Avatar

take off your harmonic balancer the answer is behind

User Avatar

The thermostat on a 1992 LeSabre should be inside of the top radiator hose inlet. You can easily change it by removing the top hose and water inlet.

User Avatar

I had the same problem with a 1992 Park Avenue with the 3800 engine. I first replaced the electronic ignition but that did not fix the problem. I then replaced the crankshaft heat sensor. That fixed my problem.

User Avatar

how to replace spark plugs wires 1992 buick century v 6 3300 stationwagon


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.