its on front of head drivers side of car just under edge of plastic intake remove bolt from it and pull out of head
They told me that i needed to replace the ignition coil on my 2004 Suzuki Verona, my question is how do i know which to change because i just found out the are 6 of them. Do i have to replace them all?
2000 suzuki vitara 2.0 crankshaft sensor
where can you find the idle of suzuki verona?
Bank 1 is cylinder 1 side of the motor. Sensor 2 is the back oxygen sensor (after the catalytic converter.
2004 Suzuki Verona: the transmission starts off in third gear..idle Here's one for you ..... My Verona started doing the same thing . Checked the code (crankshaft sensor A low voltage) cleared the code , but it came back ...Checked all fuses, all OK.. Started the car , while running pulled the fuse for trans control mod . Light stop flashing ... Put the fuse back in . No more shift problems .....
you have to separate the engine and tranny to have access!! very labor intensive
try replacing the crankshaft position sensor
Per Suzuki Dealer ...Under the Intake Manifold near back of Engine Block, Unless you have an all wheel drive These are supposed to be internal.
My past experience was to call Suzuki with your vin#
There is a butterfly valve in the air intake that the accelerator cable ends at. The tps or throttle position sensor is on the opposite end of the axis from where the throttle cable attaches.
Put in 8qt's.
I fought with my axle nut on 2004 suzuki Verona for hours, then finally checked and it called for 236 ft/lbs.