answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you replace a ecu on a discovery 2?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace ecu on 2001 Chevy cavaliar?

ecu?


How do you replace the ecu on a 2004 dodge stratus?

You bring it to a mechanic..


Can you help spark condition car died no signs of anything replaced icm replaced blown cap in ecu then blew the new one?

replace ECU with identical ECU


How much does it cost to replace the ECU in a 2002 Nissan Sentra?

The ECU part for this car runs $150 to $300. To replace it, it can run the cost up another $100 to $200 if a person does the replacement at a shop.


How do you replace the ECU on a 1992 Honda Prelude?

the ecu should be under the carpet on the passenger side. unplug the old one and plug in the new!


Can you split the pump from the ecu on an abs unit to replace it or do you have to replace it as one?

It only comes as one whole unit. and yes you will need to replace it as one


How do you replace ecu on 1992 Nissan Sentra?

ECU is located in the floor under the radio console. It has two 10mm bolts in front and a 10mm bolt in the plug also you have to unplug the green relay located on the top of the ECU.


Where is the ECU on a 1991 Honda Civic DX and how do you replace it?

It's on the front passenger floor board....Disconnect Negative battery terminal. Remove the carpet from the top. Remove the ECU cover. Remove the ECU retaing screws. Disconnect the connector and pull out the ECU..........Installation in reverse.....


How do you stop speed governor from ecu?

Either replace the ECM or reflash it with new parameters.


How do you replace the ecu in a Honda Prelude?

the ecu should be under the carpet on the passenger side or possibly unde the dash in the center. unplug the old one and plug in the new!


Why did hub replace discovery kids?

Marketing reasons.


Hey i have a 1997 Mercedes E320 and the check engine electronics is appearing and it runs about 40 mph and it feels like it pulls back like a standard car what could be the problem?

Seems to me like you have symptoms of a bad Engine Control Unit, The ECU directly ties to your emmission system, which controls acceleration, have you tried erasing the fault code with an OBD 2 scanner, pretty simple you could buy this scanner from Ebay for about $80.00. just plug it above your pedals, message gone and will also give you a code, if your ECU is bad, then you will have to replace the ecu, Get the part # from the dealer of the ECU, buy it from Ebay for about $200.00 replace it, erase message again with scanner. save a bunch of $ Seems to me like you have symptoms of a bad Engine Control Unit, The ECU directly ties to your emmission system, which controls acceleration, have you tried erasing the fault code with an OBD 2 scanner, pretty simple you could buy this scanner from Ebay for about $80.00. just plug it above your pedals, message gone and will also give you a code, if your ECU is bad, then you will have to replace the ecu, Get the part # from the dealer of the ECU, buy it from Ebay for about $200.00 replace it, erase message again with scanner. save a bunch of $