* Apply the parking brake raise the vehicle and support it securely on jackstands * Disconnect the negative battery cable and disconnect any wiring that would interfere with bumper removal * From below remove the splash panel below the radiator and bumper * Remove the radiator grille and remove the headlight housings,turn signal lamps and cornering lamps * Remove the headlights and cornering lamps and remove the fasica to fender fasteners then remove the remaining fasteners and the bumper cover taking care to avoid damaging the cover and the fenders * Working under the vehicle remove the bumper beam mounting bolts Note:The bumper beam brackets can be removed from the chassis by removing the nuts from the studs at the back of the bracket or removing the foam inserts to access the front mounting bolts once the bumper cover is removed * Detach the bumper assembly from the vehicle
don't have 1
get another one and put it in
yes
behind the front bumper on the chassis.
Spray some PB Blaster on the rusted bolts. Remove bolts and take bumper off. Install new bumper and new bolts. Used anti-seize on the bolts.
yes
Remove the left fender panel in front of the wheel well. It is located between the fenderwell and the front bumper. Usually 8 sheet metal screws need to be removed.
It's under the front bumper on the drivers side
(1993 Pathfinder XE) First start by taking the front bumper ends off (3 nuts on each). Then remove the entire fog light assembly including the plastic trim surrounding it. Then there will be 4 nuts on each side (8 total) in a square pattern. Remove the bolts and pull.
There are four bolts attached to the frame, on either side of the block by your fan belt, it will take some muscle to bust those loose.
on a 1993 dodge truck They should be right behind the front bumper
no it wont different body style