Want this question answered?
carefully
Under the front panel of the car
Remove the screws inside the door opening which secure the lamp unit. Remove the lamp by pulling towars the rear of the vehicle (there'll be some resistance until the clips release). Remove the lamp socket by twisting and pulling out. Replace the bulb. Replacing lamp unit is reverse of removal.
how do you take out the front signal lamp on a 2004 range rover
# Disconnect and isolate the battery negative cable. # Remove the screw that secures the inboard side of the front park/turn signal lamp unit to the front bumper fascia. # Pull the inboard side of the lamp away from the fascia far enough to disengage the tab that secures the outboard side of the lamp from the slot in the front bumper fascia. # Disengage the lock feature and disconnect the wire harness connector from the lamp socket. # Remove the front park/turn signal lamp unit from the vehicle.
Place vehicle in safe parked position. Crawl under front bumper. Reach up and turn lamp housing counter clockwise. Housing should drop down to about the bottom of the bumper. Replace Bulb. Re - Insert Bulb Housing in Lamp and Turn Clockwise to secure.
Remove the outer plastic trim to reveal the lamp frame holding screws. remove the frame and the lamp comes out the front
How do you replace interior door courtesy lamp?
look in your owner's manual
To replace the headlight assembly on on 03 Jetta, the grill and front bumper have to be removed before you can get to the screws below the lamp.
The fog lamp bulbs should be able to come off from behind the fog lamp. Reach under the front bumper and find the harness to the fog lamp, give it a 1/4 turn and it should pull straight back. Once the harness is removed, the bulb should come with it. Pull the lamp off and replace it with the new one. Make sure not to touch the new bulb with bare finger as the oil on your finger might cause the lamp to burn out faster. Then just do the previous steps in reverse order.
how to replace tail lamp 2005 xterra