0
There are two lights to each side, (low and high) at the back of the headlight assembly. It is accessed from under the hood. You will see where the wires go into the Headlight assembly which is the connector for the bulb. That turns about a 1/4 turn and then slides straight out. Once you have the light out you have to squeeze the base of the connector to release the bulb. The bulb is held in by a small plastic lip that when you squeeze the base of the connector is freed up. You pull the bulb straight out, but you will most likely have to apply some muscle as the lights are weather tight. That means they have a rubber or silicone weather strip around the base of the bulb that seals out water and it can make for a very tight fit. When you have the bulb out just replace it with the new one being careful of 2 things. 1-Don't touch the bulb as your skin oils can prematurely ruin the bulb or worse yet make it pop. 2-Make sure you put the correct watt bulb into the correct side. Each assembly has a high (60 or 65 watt) bulb and a low (50 or 55 watt) bulb. If you don't put the right one in the right side you could inadvertently turn on your high beams every time you turn on your lights and the oncoming drivers will be blinded by your lights.
What else can I help you with?
Where is the ecru on a 1997 Mitsubishi 3000 gt?
it is located behind the radio
How do you replace a water pump on a 1994 Mitsubishi 3000 GT?
boo
What year window regulator will fit your 1999 Mitsubishi 3000 gt?
1997 thru 1999
Fuse box diagram for a 1997 Mitsubishi 3000 gt?
A diagram can be found in the related links.
How do you replace the headlight bulbs in a 1999 3000 gt SL?
To replace the headlight bulbs in a 1999 Mitsubishi 3000GT SL, first, open the hood and locate the headlight assembly. Remove the retaining clips or screws securing the bulb cover, then carefully disconnect the electrical connector from the old bulb. Replace the old bulb with a new one, ensuring not to touch the glass with your fingers, and reattach the connector and cover. Finally, test the new bulb to make sure it's functioning properly.
Why would only the dashboard lights not be working in a 1997 Mitsubishi 3000 GT SOHC and fuses have been checked?
I believe the dash lights and tailights share the same circut. check the tailight relay and fuse located in the engine compartment rt. side above headlight
Where is the oil pump located on a 1992 Mitsubishi 3000 GT VR4?
inside timing cover.you must r&r engine to replace however.
What does 3000 gt means?
3000gt is a Mitsubishi car.
Where is the inertia switch on a Mitsubishi 3000 GT?
in the trunk
How do you change an alternator ground wire on a 1994 Mitsubishi 3000 GT?
Refer to your service and user manual on how to change an alternator ground wire on a 1994 Mitsubishi 3000 GT.
How do you replace alternator on Mitsubishi 3000?
To replace the alternator on a Mitsubishi 3000, first disconnect the negative battery terminal to ensure safety. Remove the drive belt by loosening the tensioner, then unbolt the alternator from its mounting bracket. Disconnect the electrical connectors and the positive battery cable from the alternator. Install the new alternator by reversing these steps, ensuring all connections are secure and the belt is properly tensioned before reconnecting the battery.
Change alternator Mitsubishi shogun 2.5 d?
how to change an alternator Mitsubishi shogun 3000 v6
