Chevy Blazer
Chevy S-10
Chevy Blazer S-10

How do you replace a hinge pin on a 1987 Chevy blazer?

141516

Top Answer
User Avatar
Wiki User
Answered
2008-06-24 19:50:43
2008-06-24 19:50:43

break off the bottom bushing that hold door pin pick up on the door slightly use a hammer and screw driver to drive pin out and replace

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Are the door interchangeable on an 1987 chevy truck and an chevy blazer 1988

I have a 1987 Chevy Blazer S 10 4X4 2.8l V6 and the timing recommendation is 10 degrees.

Chevy S10 fuel filterI am looking for the fuel filter on a 1987 Chevy s10 blazer 4x4. I looked at the driver side frame rail and cannot find it. Can anyone help.

A 1987 Chevy Blazer uses R12 refrigerant as shipped from the factory. Most have been converted to the more environmentally friendly R134a.

I have a 1987 Chevy Blazer S 10 4X4 2.8l V6 and the timing recommendation is 10 degrees.

The gross vehicle weight of a 1987 Chevy Blazer K5 is 4,500 pounds. The gross weight takes into consideration the weight of the vehicle in a ready to drive state.

The ECU may be creating a short circuit. Check the ECU on the 1987 Chevy Blazer and make sure it is expelling to correct amount of safe voltage. If not the computer should be replaced.

did you check your battery and alternator?

Look near the rear of the transmission on the driver's side.

It is tucked in close to the power steering pump, not easy to get to.

yes it will up to 93 as long as they are bothe 4wd or to wheel drive

how do you replace3 dimmer switch 1987 chevy silverado 4 x 4

How do I replace the side mirror on a 1987 AMC eagle

The ignition module is located in the distributor, under the distributor cap.

i am verry familiar with this motor, i know it inside and out. the 1987 makes 205 horses with its throttle body injection. the 1986 k5 blazer made 210 horses with its 4 bbl carb.

if its a 1987-1994 unhook the coolant tank unplug heater motor and 5 or 6 bolt off heater motor and you are done to put on reverse process

You must remove the fuel tank, unless you can access the pump without removing it. I have seen some people remove the bed instead of removing the fuel tank. Your choice.

the linkage to the transmmison probably needs to be adjusted

There are two size fuel tanks if this blazer in question is the s-10 version. 13.2 gallon i believe is for the 4cyl model and the 20 gallon is for the v6 size


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.