0
Air filters n manifolds
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you replace an intake manifold gasket on a 2001 Grand Am GT?
how to replace a distributor gasket on a 2000 Pontiac grand am 3.4l
What is the labor time to replace intake manifold gasket on a 2001 intake manifold gasket?
around 6-7 hours according to AllData
How do you change intake manifold gasket on 2001 stype Jaguar?
jaguar 2001 Lower Engine Intake Manifold Gasket
How expensive is to replace the thermostat of the 2001 aztek?
i have a quote from 280 - 400 $us
When there is gas in the oil on a 2001 neon can it be a head or intake gasket?
I don't know which one was at fault but I replaced the head, the head gasket, and the intake manifold gasket.
Where is the upper intake gasket on a 2001 Chevy blazer?
It is between the upper and lower intake manifold. The gasket is an o-ring type.
How do you replace lower intake gaskets on a 2001 ford escape?
Remove the air intake, throttle cables, and throttle body. Remove vacuum lines then unbolt and remove the upper intake. Remove the fuel rails. Unbolt the lower intake and remove the intake to replace the gasket. Reverse the process to finish the installation.
What is the cost to replace the intake manifold?
what is the cost to replace a 2001 v-8 manifold intake
Why would the temp gauge show hot even though its not on a 2001 Pontiac Aztek changed thermostat intake gasket and temp sensor?
thermostat may be sticking and that cause the gauge to show hot, have it checked soon, you could be headed for bigger problems
How much does it cost to repair a blown head gasket on a 2001 Pontiac aztek?
Any where from 1,000 to 2,000 dollars depending on labor and the parts
How do I change the valve cover gasket on a 2001 Toyota Rav4?
how to replace valve cover gasket toyota rav4 2001
Where is the knock sensor located in a 2001 Chevrolet Silverado?
The knock sensor is located UNDER the intake. You have to pull the intake off. I had a mechanic do mine. he said its best to replace both because they both corrode. (2 sensors, intake gasket, labor ($250)
