Caution:On models equipped with Delco-Loc 2 or Theftlock audio systems make sure you have activation code * Disconnect the negative battery cable * Drain the cooling system * Disable the airbag system.Disconnect the forward discriminating sensor harness from the front fenderwell.It may be necessary to remove the hood latch mechanism in conjunction with the airbag sensor and secure them together and out of the way during the radiator removal * Remove the cooling fan assembly * Disconnect the upper and lower radiator hoses from the radiator then disconnect the coolant recovery hoses at the radiator neck * Remove the automatic transaxle cooler lines if equipped from the left tank of the radiator * Remove the hood latch support from the upper tie bar on the front of the engine compartment * Remove the right and left headlight assemblies from the vehicle * Remove the condensar mounting bolts from the radiator assembly * Remove the tie bar (crossbeam) from the engine compartment * The radiator can be removed from the top with some wiggling to clear various components
To change the radiator you need to remove the top radiator cover bolts drain the radiator drain plug on the bottom. next remove the top and bottom radiator hoses. Next remove the steel lines going to the radiator and then take it out. be care full when you install the new one not to strip or cross thread the steel lines, I would start them first by hand and after you have both started well you can tighten them up. Put on the bottom hose and tighten and you can fill it part way at the top hose or fill it at the over flow tank, this is a sealed radiator with no cap on it just the over flow be sure to install all the hoses and lines and the cover as needed. If you fill at the overflow tank you will need to start it, let it get to running temp and shut it off to cool and suck the fluid from the tank, repeat as needed. DO NOT DRIVE IT UN TILL THE RADIATOR IS FULL OR YOU CAN DO ALOT OF DAMAGE OVERHEATING IT!!! Its not as bad as it sounds, just take your time.
The best way to do this is to visit a mechanic. There is a lot that goes on with the radiator and it can be a mess if you do it wrong.
Yes.
GM doesn't use inertia switches.
hi, i need to know how to replace the heater core with a/c on a 1994 gmc jimmy. a diagram would be helpful
I need info on replacing a fuel filter in the carb of a 1985 GM jimmy 4 wheel drive
for what car? 2000 gm s15
Remove the dash on the passenger side. Good luck, this is not an easy job.
How to replace passenger side view mirror on 2000 GMC Yukon?
The v8 engine 2002 GMC Jimmy 6 cylinders can be replaced with the GM Vortec 4200 straight-6 engine.
if its a 1996 there was a recall on that call a gm garage adn ask .............
No there is not.
GM Part #10248414 - Outside Air Temperature Sensor - located passenger side directly between radiator and grille; mounted to radiator frame left side.
Cooling lines from transmission to radiator?