How do you replace the starter on an 88 Fiero GT?

Answer 1

Replacing the starter in a 1993 Mercury Capri requires the following steps:

• Disconnect the battery by loosening the negative cable
• Locate the starter on the passenger side of the engine near the transmission
• Disconnect the starter wiring harness
• Remove the starter mounting bolts and remove the starter
• Install the new starter making sure to line up the mounting bolts
• Tighten the mounting bolts to secure the starter
• Reconnect the starter wiring harness
• Tighten the negative cable to the battery

Once all the steps above have been completed the starter in a 1993 Mercury Capri should be successfully replaced.

Answer 2

when i changed the starter on a 93 tracer i think it was 3 bolts i needed to undo and then i just took the old starter out and put the new one in make sure all the gears are in place with each other so they don't start that's basically all i did when i did it but make sure its the exact same starter to be replaced some may look like they fit but they don't so ya.

Answer 3

if this is your first, I'd get a manual... see if your local library has a shop manual for free d

Answer 4

It is best to contact a local mechanic when replacing a starter on a vehicle. If not them find a repair manual for the vehicle and be very careful.

Answer 5

Remove the positive cable from your 1993 Mercury battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

Answer 6

poopydick