to replace the tail light open the hatch look on the side of the light you will see two screws remove them. Pull the light out, take the three bulb out
ken
The only ways to improve mileage are to check tire pressures, replace spark plugs, replace air filter, repair any causes for the check engine light to be on.....
The door being open.
The check engine light on a 2000 Plymouth Grand Voyager will come on when an error is detected by the vehicle's computer. The cause can range from low oil to mechanical problems or incorrect timing.
The maintenance required light requires a scan tool to be reset.
the reverse light switch is usually mounted on the shifter inside the car.
2 screws, up/down. left/right
A turn signal indicator can be replaced by first removing the burnt out light inside of the glass chassis. The new bulb will then be installed in the same fashion.
To change the headlight assembly in a 1995 Plymouth Voyager, first, open the hood and locate the headlight assembly. Remove the retaining screws or clips securing the assembly to the vehicle. Carefully pull the headlight assembly out and disconnect the wiring harness. Replace it with the new assembly, reconnect the wiring, and secure it with the screws or clips before testing the light.
The plastic is melted on the back of the light wear the two metal touches
To replace the dome light on a Grand Am, unscrew the light cover. Pull it down gently. Disconnect the light. Connect the new light, replace the light cover, and replace the screws.
Adjust or replace the back up light switch, located somewhere next to the shift lever.
I have a 91, it was real simple. Lift the hood and reach in right behind the front light, you will see where there is a cord attached to the light bulb, disconnect it. Untwist the circular ring and the bulb pulls right out. Replace bulb and backtrack to put back together.