You dont need to replace the motor just fix it. Remove the door panel by taking out a couple of screws around the inside door handle, the bottom rear of the door and pull the panel up and out. Unplug the window, door lock and courtesy light plugs. You will find three bolts that hold the motor in place. Remove them and the motor will fall out. Now unplug the motor and it is ready to fix. There are a few people on eBay selling the bushings that go bad, buy one of these kits. Each motor gear assembly has three bushings, they are sacrificial and will rot over time, it they where not there damage to the motor gears could occur they protect against it. The bushings can be tricking to get in, but if you get all three of them diagonally in and push hard they will slide in. When putting the motor back in make sure the outer gear goes onto the crescent shaped large gear in the door, if not you will just be putting the motor outside the gear. Put the connectors and door panel back on and you have spend one hour and $9 (That's what I paid for the bushings on eBay)
how to replace1994 grand drivers side power window motor
for what car? 2000 gm s15
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
Buy a chilton's or haynes maintenance manual. They tell you everything. I had to replace my drivers side window motor. Not too hard.
replace the power window motor inside the door. You will have to drill out the rivets and replace with nuts and bolts
First... get a repair manual. Follow the instructions...
you need to replace the window master switch
video on how to replace window lift motor on j30
Replace the window regulator, it may come with the motor.
The window is not off track. The window regulator is broken. In most cases you will have to replace the window motor and regulator as an assembly.
Remove the door panel and unclipped the three plastic retaining tabs that hold the window motor in place disconnect wire connector and it's out
How to remove the window motor from the regulator