answersLogoWhite

0


Best Answer

no

User Avatar

Wiki User

2013-10-07 22:51:29
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you replace a water pump on a 1988 Buick Regal?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the head gasket in a 1988 Buick regal?

Procedure to change 1988 Buick regal head gasket


What is the cooling system refill procedure for a 1988 Buick Regal?

A 50/50 mixture of antifreeze and distilled water.


Where is the gas pump located on the 1988 Buick Regal?

It's in the fuel tank.


Why would the throttle stick down on a 1988 Buick Regal?

Lack of lubrication perhaps?


What type of coolant is recommended by the manufacturer of a 1988 Buick Regal?

Regular green antifreeze of any manufacturer will be fine in a 50-50 mix with water


Why does your 1988 Buick Regal not start when you try to crank it after it has been running?

if it has a crankshaft sensor that's bad


Where is the freon valve located on a 1988 Buick Regal?

Freon valve on my 1989 Buick Regal Custom 3.1 V-6 located on driver side under the area of battery tray. Hope this helps!


Where do you put the transmission fluid in your 1988 buick regal?

Use a small hose or funnel and put it in the dipstick hole


How many gallons of gas are in a gas-tank of a 1988 Buick Regal 28 engine?

it says 16.8 gal. on manual...


Where is the location of the cam sensor in a 1988 Buick Regal with 2.8 engine?

The 2.8 engine doesn't use a cam sensor.


How can you bypass heater core on 1988 Buick Skylark?

You can bypass your 1988 Buick Skylark heater core by removing the heater core water supply hoses. There will be to water hoses. Connect the water hoses to each other.


What could cause an 1988 Buick Regal Ltd to idle OK but stalls when the accelerator is pushed in more than 1 inch?

dirty throttle plate.....

People also asked