Take off the door pnl by pulling off the speaker grille you will find a screw, another screw is on the side of the door pnl by the door lock button (kind of in the jamb area), there is another screw behind the carpet on the bottom of the door pnl (you removed this carpet by prying it out with a screw driver very carefully), pull off the trim that goes around the pnl with the seat adjustment switches and remove the screws around that plate with the switches for the seat and the door lock switch then unplug the 2 plugs behind it, then through the holes where you removed the carpet piece take an 8mm or 5/16 socket and remove the chrome handle you open the door with, then carefully pry off the door pnl by every plastic push button with a door pnl remover tool (you can find these in any auto parts store or Harbor Freight) it looks like a Y shaped tool but it has an open elongated slot in the middle that you slip around those plastic connectors that are attached to the inside of the door pnl, if you carefully pull the door pnl out a little bit you can see them... Once you get the door pnl off carefully remove the foam piece behind it and take a flash light now and look inside to see where it is, there is another speaker hole down in the lower corner towards the front of the door you can remove it from, but you will have to unbolt it first and you will need a small hole saw and a drill... in the area where the gear head of the motor is there should be 3 tiny center punch marks where you will drill out (use a hole saw because a drill will butch up the sheet metal, get a hole saw a little bit bigger then the 8mm or 5/16 1/4 drive socket)... Now you can with a log extension go through the holes you drilled and remove those bolts carefully while holding onto the motor and remove it though that speaker hole and unplug it... When installing the screws I always use a little bearing grease on the heads of the bolts so they stay in the socket and make sure you get the window motor lined up right (this is very challenging and you will need to be very patient while doing this)... Once you get it back in and plugged in give it a run up and down, you might even have to side the window down a little to get the motor to seat all the way in... Before you put the new motor in you should be able to side the window up and down by hand very easily, it's also best to grease all the sides and spray some lube on everything in there that moves (I use CRC 336 for marine use on all pivots and synthetic grease on the sides... Any binding will burn out the motor early... Then reverse the whole procedure and put everything back together!!! Good Luck!!! I can do this in less then an hr now because my car is on it's 3rd set of motors it just turned 22yrs old!!!
Remove the inside door panel of your 1988 Lincoln Town Car. Remove the wiring harness from your window motor. Remove the window motor retaining screws. Reverse the process to install a new window motor.
u have to drill out stock rivets on the door replace with quality bolts and nuts .remove motor unplug.reverse procedure to install new motor its pretty simple..
The 1988 Chevrolet Blazer tailgate window motor might be bad and need to be replaced. The window motor fuse might be blown and needs to be replaced.
Only if you change out the entire regulator. The power regulator unit is pitched a little different due to the power motor components.
Front or rear?
Remove the oil pan and there it is...
I have repaired both electric windows in my 1988 caravan. There is a white plastic track that the motor pulls and pushed and this is what opens and closes the window. It is located inside the door behind the door panels. Usually the track breaks, with age and you need to replace them.
Remove motor mounts and raise motor approximately 4 inches.
No, but hear are the years that will work. 1988 to 1995 350 engines.
Take off the inside door panel, (pull plastic clips, usually spaced 8-9") remove wire connection then mounting bolts. Just reverse process to install.
What size motor? What accessories do you have? BClear.
Lincoln - 1988 was released on: USA: 27 March 1988